Car stops when I slow down so looking for the location of the the Crankshaft sensor pole so I can change it. Not very mechanical so please minimize jargons if possible, many thanks.
SOURCE: Nissan Almera Tino Right hand side
YEs but if you are going to do some secrifice on your luck of car model from front,
otherwise its impossible,
you can get this from older car dealer or service center,
TNX
SOURCE: Nissan Almera Tino Diesel 2.1 - Temperature control not working
Hi there, very common on these vehicles, you need to remove the heater cotrols and check that the cable hasn't come out, usually the clips that hold the cables in place break causing the heaters to not work properly, Nissan do modified clips now to stop it from happening, it may need a cable too if its too far bent, hope this helps.
SOURCE: crankshaft and camshaft sensors location in nissan altima 2003
You are incorrect sir. There is a very good Youtube video showing you exactly where it is that is how I changed mine. The Crankshaft is located behind the engine block below and around from the cam sensor which is easly spotted looking at the engine. The crankshaft is in a difficult spot but once you figure out where it is it's easy...ish hope this helps
SOURCE: the malfunction indicator light came on, on a
take the malfunction light bulb out ,if it runs ok then leave well alone
757 views
Usually answered in minutes!
×