Question about 1995 Chrysler LHS

1 Answer

The A/C doesnt work although its topped out. - 1995 Chrysler LHS

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 108 Answers

Verify compressor operation. With it idling have the hood open and watch the compressor, and make sure the center of the wheel turns. If it doesn't then you either have a bad wire, fuse, relay, pressure switch, or compressor clutch. Check the fuse first, if its good then locate the pressure switch, most of the time its on the drier near the front behind the grill or near the fire wall at the passenger fender. Pull the connector off and there should be two pins in the connector. Take a jumper wire or even a large paper clip will work and connect them together to see if the compressor kicks on. If it does then you have a bad switch and will need to be taken to a shop that can drain and recover the AC coolant. Take it to a shop that can put the old freon back in it. And try to be in the shop when they do the work so that they can't charge you for new freon if they put the old back in. My AC doesn't work due to a bad pressure switch. And make sure you don't run it with the pressure switch bypassed, otherwise the system will blow up.

Posted on Jul 15, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How does a 4x4 work?

Some thing has to put it in 4x4 (shift handle or switch etc) although some jeeps are fulltime 4x4. More info please.

Feb 27, 2016 | Cars & Trucks

1 Answer

I have a sabb 99 convertible an the trunk warning light won't go off .which is stopping the soft top from going down ... Help !!

Convertable not so fun when the top doesnt operate? Haha.
there is such a thing as a trunk lid sensor. Although I dont know
where its located, its a good place to start.

Jun 30, 2014 | 1995 Saab 900

1 Answer

Temp gauge keeps going to hot...

Check your water pump and ensure that your Thermostat is installed correctly - it may be reversed.

Jan 15, 2014 | Dodge Durango Cars & Trucks

1 Answer

Concerning OnStar FMV- The red light remains on after I start the car and the small triangle on the top blinks yelloe. Does anyone have any ideas why?

check the brake fluid level ,top up if needed although this is a sign the brake pads are worn down but anyway top up fluid and if still doesnt go out then remove the cap and shake it as the ball valve float contact sensor can stick .check brake pad thickness straight away and look behind rear drums for sign of a fluid leak

Sep 16, 2011 | Volkswagen Jetta Cars & Trucks

1 Answer

When starting my estima emina 2.2td manual there is a heavy rattle from around the bell housing, pressing the clutch doesnt effect it although you can feel it through the pedal when depressed,have removed...

I have the same problem few days ago and found my solution on Fixya Expert Sources website. Here you will get all the top sources of your problem. All the sources of this site provided by top Fixya Gurus. Have a good look at the sources on top of the page. Go through the sources to find your solution. Hope it will help.

View Count:8

Aug 09, 2011 | 1995 Toyota Previa

1 Answer

I have a 98 cherokee and the driver door doesnt lock with the remote or with the panel switch- although i can hear the motor whizzing. it will however lock manually. also, it SOMETIMES(although very...

the lock motor could be jammed or a gear inside it could be broken. best bet would be to go to a parts store or junk yard and get a new one and try that out.

Feb 23, 2010 | 1998 Jeep Cherokee

1 Answer

Gas guage not working

Sending unit in the gas tank. Although sounds like possible loose connection considering that it did work momentarily

Sep 03, 2009 | 1999 GMC Yukon

1 Answer

Top, Heater, Windows not working

Did you ever fix this problem or find a solution? I have the SAME issue in a non-convertible (heater, windows - and horn & wipers).

Please email me if you found a solution! josh at boostvt dot c0m

May 18, 2009 | 1997 Saab 900

1 Answer

Gas gauge works than doesnt than works again

This is the sensor in your fuel tank, they have little brushes on them that run on a reostat. it is a common problem, I have been able to remove them and fix them, although the best option is replacement.

Jan 14, 2009 | 1999 Chrysler 300M

Not finding what you are looking for?
1995 Chrysler LHS Logo

152 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

80608 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides