Are the rear windows in a peugeot 407 electric or manual all i have is 2 round holes where switches or winders go please help

SOURCE: need to change rear pads and adjust hand brake on a 407

right the hnad brake is located on the center console at the right of you in america or left if you are are from brittan. pull it=]

SOURCE: The electric windows on my peugeot 306 don't work

Hi,
It sounds like a power supply problem. I can't see all 4 motors broken.
First how does the switch "feel" No buttons loose?
Does it illuminate when you switch sidelights on?
If that's ok
I would gain access to the master switch on the drivers door.
I would think you have to remove the door panel and armrest I can't remember for sure, but it doesn't take a lot .
Check and make sure all the multiplugs are connected first of all.
Make sure all the terminals in the plugs are fully "home"
If there is nothing obvious i would follow the loom to where it exits the door and goes back into the car and check for damage.
Check for ANY other electrical equipment not working, if so go back to your handbook and re-check which fuse it goes through.
Also, if this problem has occurred after a recent repair, I suggest you return to the repairer.

SOURCE: Removing Peugeot 407 Petrol 1.8 Spark plugs

try autozone.com to see if they have your car listed for diagrams pictures and step by step instructions if your car is not listed then try your local library they have all the car manuals and even copy them for you

SOURCE: Peugeot 407 not 405 blocked windscreen washer

its in the pump it self mate ya have to take the pummp out of the bottle

SOURCE: peugeot 407, 2.0 litre diesel, 05,loss of power/air surge heard

I am not familiar with the 407 but I would think it is a HDi, if so what you describe is an air leak from a pipe from the pressure side of the turbo, I have had this on a Saab, in that case there was an over pressure switch under the dash and the pipe fell off. Look at the top of the engine, on the inlet side there will be a pipe from the inlet trunking or manifold, it should (maybe with a tee piece in there) go through the bulkhead