Question about 1999 Dodge Ram

1 Answer

Truck runs fine but wont shift

Truck was running good on the way home and when I stepped on the gas the motor took off but the truck dident I can get 20mph and it wont shift is this the speed shift sensor?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,392 Answers

Possible output speed sensor, possible solenoid pack, possible bad transmission. Those trucks were known to have problems with the trannies. If you haven't been servicing it at least every 30K, that is most likely the problem.

Posted on Jul 15, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

91 jeep cherokee trany slips


Your done once it slips

Have to rebuild or replace

Sep 03, 2012 | 1991 Jeep Cherokee Limited

1 Answer

99 E250 when motor is running van wont shift out of park when motor is off . when ignition is on and motor not running it will shift just fine


the shift interlock is not releasing. You are doing emergency release procedure with engine off and key in off position.
Likely you don't have brake lights either. When you step on the brake with the key ON, it releases the shift lock solenoid (and turns on the brake lights).
Check to be sure the brake light switch on the pedal arm has the wire going to it and you can hear it click on and off.Check the fuse for the brake lights too.

Feb 14, 2011 | Ford E-Series Van Cars & Trucks

1 Answer

My girlfriend took off this morning to do somethings and got gas and everything was ok then she came home and then i left and the car started up ok and i took off and got about 2 miles from home and the...


sounds like bad gas

disable the fuel pump and spray carb cleaner into the throttle body

assuming the car starts then you have confirmed the bad gas theory

most bad gas is the result of water so buy 2-4 bottles of "Gas Dry" and see if that helps

otherwise you will have to get the tank drained and refuel with good gas

Keep us posted

Apr 12, 2010 | 2004 Dodge Stratus

3 Answers

Car won't start not the battery


Test the neutral safety switch but doing the following steps.

1)foot on brake
2)turn key to on position
3)shift lever to neutral (N)
4)start the engine
5)shift the lever to Park (P)

If the engine can start at N and not at park then it's the neutral safety switch.


Dec 01, 2009 | 1999 Ford Taurus

1 Answer

Why wont my 96 chevy cheyenne 5.7 run unless i put


Probally needs fuel pump. Pump is in the tank. remove gas cap listen when you first turn on key it will run for a few seconds.

Sep 25, 2009 | 1996 Chevrolet Crew Cab

2 Answers

Transmision wont go in R 2 4 but 1&3 is fine


Do you have a check engine light? If so,get it checked out. (Free at most major auto parts stores). It sounds like it's in limp home mode. The manufacturers made the electronics so that you could still get it home if any of the electronics failed. Sounds like your shift solenoids have failed you, but it's anyone's guess until you get the thing scanned. No one on here can give you a definate answer until that happens. Find out what codes it's showing and then get back on here with them. I took the time to answer, now please take the time to rate my answer.

Sep 04, 2009 | Hyundai Motor 1997 Tiburon

1 Answer

5 speed manual trans wont go into 2nd


the syncronizers are out on your trans for third gear and as far as the lifters try running some high octane gas with some oil and gas treatment before going into the motor to eliminate that first.

Jul 28, 2009 | 1992 Dodge Dakota

1 Answer

Bronco tranny wont shift out of first


sounds like you burnt it up. how long did u drive it like that?

Nov 04, 2008 | 1989 Ford Bronco

Not finding what you are looking for?
1999 Dodge Ram Logo

Related Topics:

255 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...