Question about 1995 GMC Sierra C1500

1 Answer

95 Sierra auxiliary A keeps shorting out.

I am not sure what is causing it, but there is obviously a short somewhere in the system. I was checking the fuses in my dad's truck, a 95 gmc sierra 4wd, and the auxiliary A fuse which is a 30 amp was blown. I put a new one in but it blew immediately. I cannot figure out what aux. A fuse is for. I didn't notice anything in particular not working on his truck.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 69 Answers

It sounds stupid but check inside the cigarette lighter holes and the cell phone charger holes 2 times i had some blowing fuses with no reason on the first one i found a piece of gold in front cig lighter the owner was a jewler it was some scrap gold he put in ash tray the 2nd in rear cig lighter the waman's kids had put some dimes in it it can drive you crazy but so simple once u find it ..no promise but its a start....

Posted on Jul 15, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

95 GMC Sierra horn does not work, fuse keeps blowing.


the fuse blows because somewhere after the fuse , the wire is dead shorting out to ground
check / replace any horn relays

use a multimeter set on ohms resistance and that will tell you that it is shorting out as it will register as a circuit

Jun 27, 2017 | GMC Cars & Trucks

2 Answers

I have a Ford Festiva and my indicator fuse keeps blowing out, anyone know what this problem would be?


Obvious short circuit probably caused by spring contact at base of bulb. bulb holder deformed or bent. they still use this design in many trailer lights.

Dec 02, 2014 | Ford Cars & Trucks

1 Answer

My 2000 crown Victoria keeps popping my dashbord light fuse!!!


If the fuse keeps blowing, you have a short circuit to a ground somewhere. The fuse protects the wiring from burning up. They, tool companies, make a short tester that takes the place of the fuse and buzzes when the short is present and stops buzzing when you move or locate the wire that is "shorted". Repair the wire that is touching a ground an the harness somewhere and then replace the fuse. Good luck, could be obvious like a coin stuck in the cigarette lighter or just some wiring someone has done recently.

Oct 15, 2014 | 2000 Ford Crown Victoria

1 Answer

95 ford mustang starter fuse keeps blowing. what should i do?


have you checked that the starter itself has not been grounded out (short in the wiring?)
The chances are this is what is causing your problem, start at the starter motor & follow the wires, check every single one, if you have a bare section that comes in contact with the body or anything else metal it will ground out that wire & cause the fuse to blow every single time even if you were to double the fuse resistance I.E. if the fuse is a 20 & you put in a 40 it will still blow - that last part is ill advice - never put a higher amperage fuse in a socket that was intended for a lower amperage fuse - it could cause a fire & serious injury, check all your wiring from the starter you have a short in the system somewhere it's just a pain in the a
4rse locating it

Sep 21, 2012 | 1995 Ford Mustang

1 Answer

ECM I fuse keeps blowing in my 1996 1 ton gmc sierra 4x4 with a 454 v8 engine whats causing it


For the ECM 1 fuse to open you obviously have a short to ground , start with the injector disconnected and see if ECM 1 fuse still blows.If it does disconnect crank sensor, also inspect wires for the injectors or any rub through wires here is a diagram cansmo_178.gif

Sep 09, 2011 | 1999 GMC Sierra 3500

1 Answer

Keeps popping a 50 amp fuse to the ignition. was driving it and it died,now it keeps popping a 50 amp fuse thats labled ignition in the fuse panel under the hood.


its shorted out somewhere check your injectors wires 1 may have had the insulation rubbed off of it and its grounding out

Nov 27, 2010 | 1998 GMC Sierra

1 Answer

The wipers keep shorting out shortly after i


There is a short circuit somewhere in the connection of the wipers,it needs to verify the connection where the short circuit come ,its due to an uninsulated wire,check it.

Feb 05, 2010 | 2003 Mitsubishi Lancer

1 Answer

Blowen fuse 4X4


obviously have a short somewhere, but need more info from you.

Dec 25, 2009 | 1993 GMC Sierra K1500

1 Answer

I have no running lights on my 1996 F150. I have chased wires as best I can, replaced the headlight switch. Headlights work but 30a fuse blows as soon as I turn them on. Turn signals and brake lights work....


If you have trailer lights make sure you don't have a short in the connector or harness. You obviously have a short somewhere after the fuse. Try unlpugging each running light. to see if its in the light connecter. also check the side markers

Aug 14, 2009 | 1996 Ford F150 Regular Cab

1 Answer

2004 yukon horn problem


obviously there is a short in the system probably in the wiring and likely it is exposed wiring. Motion,moisture, and heat would then effect the wiring and cause it too short out at different times and for varied lengths of times. driving your car would cause it to get hot under the hood, so after awhile the wiring shorts and your horn honks. Turning on and off the system causes motion and if it is stuck in a particular position when it shorts than the horn continues to honk

Jan 11, 2009 | 1999 GMC Sierra

Not finding what you are looking for?
1995 GMC Sierra C1500 Logo

171 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...