Question about 1998 Dodge Durango

1 Answer

Why is there no heat?

Replaced hose, thermostat, and heater core. Flushed it and I still don't got any heat in the car it just blows cold

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Dodge Master
  • 53,745 Answers

There could be a air lock in the cooling system and the heater core is full of air
bleed the air out or have an accredited radiator shop do it
make sure that the heater control valve is getting the signal ( cable, vacuum etc ) from the heater control switch ( climate control module) to turn the coolant system on to the heater core

Posted on Dec 31, 2015

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Getting no heat on a 1998 navigator replaced heater core an still want blow out heat


Is your air locked slacken off top hose and make sure your getting a good flow of water no air

Nov 14, 2015 | 1998 Lincoln Navigator

1 Answer

Heater blowing cold


if u flushed heater core n both hoses to heater are hot, then more than likely the blender door is not allowing heat to enter the inside of car...a lotta times itz located behind glove box where u can chek it...dependz on the car...

Dec 18, 2013 | 1999 Ford Taurus

2 Answers

Heater doesn't get hot on 96 chevy truck. Blows good, just cold. Replaced thermostat, flushed radiator. Any ideas?


Air Temperature Control Blend Door Failure No Heat or no AC (dependes on where door sticks)

In all modern cars there is a tiny DC electric motor driven gear drive that moves a plastic door that blends heated and cooled air from the AC and the heater core, this is called (interestedly enough) the air temperature control blend door actuator. The motor that moves this door fails because the door starts sticking from warping, most common complaint is no heat but it can be no AC as well. To replace these parts (blend door and blend door actuator) you must remove the entire dash from the car. Always have this problem confirmed by a dealer or qualified repair shop as it is a very expensive repair.

Other causes of no heat in the cabin are engine thermostats that are stuck open (engine runs cold) or air bubbles in the cooling system.

Dec 06, 2012 | Cars & Trucks

1 Answer

76 COUPE DE VILLE NO HEAT!!! FLUSHED COOLANT SYSTEM REPLACED ANTI-FREEZE, REPLACED THERMOSTAT TO 195 DEGREES, REPLACED A/C THERMO VACUUM SWITCH, HOWEVER FLUID IS CIRCULATING THRU HEATER CORE. THERMOSTAT IS...


Feel the hoses going to heater core, one should be hot and the other warm. If one is cold or both are then heater core is clogged. Make sure heater control valve works and as vacuum to it and or the cable is free.

Jan 16, 2011 | 1976 Cadillac Deville

1 Answer

No heat/defrost 01 corolla


Sounds like you have air trapped in the heater core when you flushed the heater core. loosen the upper most heater core hose and run the engine untill coolant seeps out. Wait until the coolant has reached running temperature.

Jan 17, 2010 | 2001 Toyota Corolla

2 Answers

Heater blows cold air, replaced thermostat &


try to back flush the heater core. and if that dont work check the blend door it see if it is working.

Oct 15, 2009 | 2002 Mitsubishi Galant

1 Answer

Heater blows cold air have replaced the thermostat


sounds like the controller went bad use temp checker see what your temp is at inlet of heater core from hose

Sep 08, 2009 | 1999 Ford Taurus

1 Answer

Heater blowing cold air


squeeze the hoses to get any air bubbles out and refill coolant as necesary. are you sure you put thermostat in the right way? may be backwards. also may be your sensor.

Jan 04, 2009 | 1991 Dodge Ram

1 Answer

No heat


Sounds like you have a clogged heater core. Sometimes heater cores can be flushed, but more times than not, it has to be replaced. If you've replaced the thermostat and your lower radiator hose is always cold, chances are it is the heater core. Hope this helps! Have a great day!

Nov 23, 2008 | 1999 Saturn SL

Not finding what you are looking for?
1998 Dodge Durango Logo

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

84625 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...