Question about 1993 Nissan Pathfinder

1 Answer

My check engine light came on after my car had stalled so I checked it at autozone.They said it was the mass air flow but that was clean.I then checked around and the air duct boot was cracked so I replaced it car ran fine for a little then I tried to start it again it started then stalled..........what do I do?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,129 Answers

It doesn't matter if the MAF looked clean it is an electrical component it is bad replace it.

Posted on Jul 14, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2005 mercury Monterey van with a check engine light on. Autozone diagnosed either a mass air flow sensor or O2 sensor problem. I tried cleaning the air flow sensor with air flow sensor cleaner but...


If it is running lean, I'd check correct fuel pressure. Then check for a vacuum leak. 02 sensors are part of a tune-up. I don't like to replace parts unless I'm sure.

I can't rule out a maf sensor.

Jul 29, 2014 | 2005 Mercury Monterey

2 Answers

PO103 and 116 code on a 1997 jetta 2.0


P0103 - Mass or volume air flow circuit high input.

Symptoms: Engine stalls, running rough, excessive fuel consumption, excessive smoke from the tail pipe, check engine light on.

Possible Causes: Dirty mass air flow sensor, dirty mass air filter, mass air flow sensor harness is open or shorted, mass air flow sensor electrical circuit poor connection, intake air leaks, faulty mass air flow sensor.

P0116 - Engine coolant temperature circuit range/performance.

Symptoms: Check engine light on.

Possible Causes: Low engine coolant level, ECT sensor harness open or shorted, ECT electrical circuit poor connection, faulty engine coolant temperature sensor (ECT), faulty engine coolant thermostat.

Apr 27, 2011 | Volkswagen Jetta Cars & Trucks

1 Answer

One min light on i checked code p0102 came up was on for a day then i used it this morning light was off for like 6hours then now its back on


The light will go on and off until the actual system has failed.

P0102 - Mass or Volume Air Flow Circuit Low Input.

Symptoms:
- Engine stall
- Engine running rough
- Excessive fuel consumption
- Excessive smoke
- Engine light ON

Possible Causes:
- Harness or connectors (The sensor circuit is open or shorted.)
- Intake air leaks
- Mass air flow sensor may be faulty

Possible Solutions:
- Replace air filter
- Clean air flow meter
- Replace air flow meter

Jan 18, 2011 | Pontiac Grand Prix Cars & Trucks

2 Answers

Engine light states "manufacturer control fuel air Metering"


You need to clean the Mass Air Flow Sensor with some CRC mass air flow sensor cleaner.

Feb 23, 2010 | 2001 Toyota Tacoma

1 Answer

1995 chevrolet blazer stalls when you slow down


try checking air cleaner box to be sealed or dirty air filter and try to clean mass air flow sensor also check for dirty air intake only clean mass with special mass cleaner . also look for vac leaks and fuel pressure .

Jan 28, 2010 | 1995 Chevrolet Blazer

1 Answer

Engine light and stalling on aceleration, hooked


oh dear, its still that mass air flow sensor playing up, there very easy to damage just one tuch will do it, try another one but be very jentel when you fit it

Oct 22, 2009 | Mercedes-Benz ML320 Cars & Trucks

3 Answers

I have a 1995 ford taurus engine stalls when idling and smells of gas when accelerating it bucks. Changed fuel filter, could it be mass air flow sensor?


Start with smaller problems and check the fuel pressure regulator, the mass air flow sensor for these vehicles is pretty pricy. Is the check engine light on? If so, head to your nearest auto zone and have them check for trouble codes. If the check engine light isn't on, its not likely your mass air flow sensor

Jul 09, 2009 | 1995 Ford Taurus

1 Answer

Regulator problems


clean the air filter and oxygen sensor located in the duct leading to the air filter. buy a can of mass air flow sensor cleaner from autozone. if that doesnt work then completely replace the mass air flow sensor , if that still doesnt work try replacing the oxygen sensor. also try putting seafoam. in your gas tank from autozone itll clean out your injectors.and if your still having problems stalling and not restarting then it could be your timing belt and you might need a whole new engine, i had to put a whole new engine in mine becuase the timing was off.

Jul 28, 2008 | 1995 Nissan Maxima

Not finding what you are looking for?
1993 Nissan Pathfinder Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...