Question about 2000 Toyota Corolla
1. Wiggle and pull the plug out of the back of the headlight. Note what is the top of the plug.
2. Pry the rubber seal from arond the back. You can start at the top with a screwdriver and then it will just peel off.
3. There is a wire spring clip holding the bulb in place. Push down on the side with the loop with he wire passing through it and push it up toward the top of the light. The single wire is hooked under a plastic notch and will release the spring clip.
4. The clip will rotate to one side and you are now able to pull the bulb out. Note the position of the contacts. One on top and two on the sides. No contact on the bottom.
5. Place the new bulb in the same way without touching the lens. Hold it from the back and slide it in.
6. Rotate the spring clip back and hook it under the plastic notch.
7. Replace the rubber seal. It is marked TOP for alignment. Push it in snug all around the rim. You can feel it pushed in.
8. Place the plug back into the light and you are ready to go.
NOTE: For the driver side, it will be the same except you must remove the battery in order to get to the bulb.
Posted on Mar 23, 2010
Open the nuts and replace
Posted on Jul 14, 2009
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
remove phillips scew and the door handle. remove padded arm rest on the door by lifting it up, and remove 2 screws. You can use a panel tool to remove the plastic toggle like pins holding the panel border in. Be as gentle as possible they may break due to becoming brittle.
Posted on Apr 06, 2009
CHECK ENGINE ON. SOMETIMES THE EXHAUST FUMES SMELL BAD. TECHNICIAN RECOMMEDED TO REPLACE THE CATALYTIC CONVERTER. PLEASE ADVISE.
COROLLA 2000 120,000 MILES
Posted on Mar 19, 2010
Open up the hood, and go in behind the fixture where the light is located. Grasp the headlamp electrical connector socket (with wires coming out of it) and disconnect it by pulling straight back. Pull off the black, soft rubber protective housing that surrounds the back of the headlamp housing. You will then see a spring clip securing the bulb. Push the clip in and up on an angle and it will release the bulb. Never touch the new bulb with your bare fingers, as the skin-oil you leave will greatly shorten the bulb's life. Place the new bulb assembly into the housing, push the clip in and up again, but in the opposite direction of the first angle to release it and it will lock. Then replace the black rubber housing-cover, plug the electrical connector back in, and you're in business.
Posted on Oct 13, 2009
Open the hood to gain access to the rear of the head light. simply unplug the light bulb, then twist then pull the bulb to remove. Do not touch the glass portion of the new bulb, the oils in your skin may cause the bulb to burn out quickly. reverse to install
Posted on Aug 23, 2010
Tips for a great answer:
May 30, 2016 | 2007 Toyota Corolla
Sep 27, 2015 | Toyota Cars & Trucks
Mar 07, 2014 | 2000 Toyota Corolla
Feb 11, 2013 | 2000 Toyota Corolla
Sep 29, 2012 | 2000 Toyota Corolla
Dec 21, 2010 | 2000 Toyota Corolla
1,808 people viewed this question
Usually answered in minutes!