Where is the shift soleniod located? - 2008 Dodge Avenger

SOURCE: dodge avenger 2008

It depends on who you go to and if you want it done right. I went to the Dealership and had them put front brakes on my 2008 Dodge Avenger and it has been in the shop every 2-4 months since then for front brakes. They replaced the entire front brake system and my 08 Avenger is still eating brakes. I finally took it to a friend who owns a auto repair shop he replace the rotors which are total about 115.00 for each from AutoZone and replaced the brake pads for 50.00 so it cost me just parts 155.00 and my Avenger is running smoothly since haven't had problems with the brakes since. Go to Midas and let them change it for roughly 89.00 avoid the dealership at all cost they can run 200.00-500.00 depending on if it is just the brakes pads or if it is the rotors and pads.

SOURCE: 2008 Dodge Avenger Gear Shift stuck in Park

sounds like the lock for it broke either from the button on the shifter or from the pedal its only plastic i would take the shifter cover off and try it then and look at all the peices too see what is not working

SOURCE: Brake Fluid for 2008 Avenger

it's DOT 4 or DOT 5 check with your manual and sometimes it's even in the fluid fill cap.

Testimonial: "Quick response, guided me in the right direction. Thanks!"

SOURCE: 2008 dodge avenger spark plug location and socket size.

• 2008+ Dodge Avenger 2.4L 4cyl.
• Remove plastic cover on top of engine, just pull on each corner for it is friction fit.
• Once removed you will see 4 black spark plug covers with one hex type screw holding each.
• Remove Hex screw and place aside, pull upward to remove plug boot from plug.
• To remove the plug, use a 5/8 socket with a 6" extension. Once plug has been turned out all the way and you cannot get the plug up and out of the hole, just press the plug boot back on the plug and pull it back up.
• Gap and replace 4 plugs with the same or equavalent type,. Drop plug down the hole and use socket to align and tighten until just snug, then torque to manufactures specifications.

Marvin

• 85242 Answers
• Posted on Nov 16, 2010

SOURCE: where is the battery located

To access the battery, turn the wheel fully to the right and remove the left front inner fender shield. The information is on page 379 of the owners manual