a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need. Goodluck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
washer fluid is simply clean fresh water with a grime busting additive added by you when refilling the bottle. Fill the bottle with clean fresh water and add the detergent in the proportion as on the bottle.( windscreen cleaner --not washing up detergent---too corrosive on the metal and paint work)
Pull resivior and see if it gelled up around screen for pump motor.Cheaper washer solvents tend to do this,If so you can clean screen and it should be ok.Note sometimes you can look down in liquid with flashlight and see gell in resivior.
Disconnect and isolate the battery negative cable.
Remove the engine fresh air housing inside the engine compartment.
Disconnect the washer hose at the in-line connector forward of
the cowl grille so that the in-line connector remains with the washer
hose from the fresh air plenum.
Disconnect the washer hose from the hose clip located on the front fender side shield.
Remove the filler tube screw.
Hoist and support vehicle on hoist or jack stands.
Remove the right front wheel and tire assembly.
Disconnect the left right front wheelhouse splash shield and move aside.
Drain washer fluid from the reservoir and into a suitable clean container. This can be done by disconnecting the windshield washer hose
from the front (outboard) washer pump and allowing the washer fluid to
drain into a container through a temporary jumper hose connected to the
front washer pump.
Disconnect the electrical body harness connectors to the
washer pump motors and the fluid level sensor. Slide the red lock on
the connector to the release position, then, depress the black tab and
pull the connector off the pump or sensor.
Remove the two reservoir mounting screws.
Disconnect the reservoir from the body mount by raising the
reservoir upward slightly and then down so that the reservoir filler
neck and front washer hose pull through the opening in the front fender
Push filler neck and front washer hose through the opening in the
front fender side shield. Connect the reservoir to the body mount by
lowering the reservoir down.
Install the two reservoir mounting screws. Torque screws to 8.5 - 11.3 Nm (75 - 100 in. lbs.) .
Connect the electrical body harness connectors to the washer
pump motors and the fluid level sensor. Slide the red lock on the
connector to the closed or locked position.
Assure that washer is properly routed to prevent pinching and possible inoperative washers.
Connect the left right front wheelhouse splash shield and move aside.
Install the right front wheel and tire assembly.
lower vehicle from hoist or jack stands.
Install the filler tube screw. Torque screw to 8.5 - 11.3 Nm (75 - 100 in. lbs.) .
Connect the washer hose to the hose clip located on the front fender side shield.
Connect the washer hose at the in-line connector forward of the cowl grille.
Install the engine fresh air housing inside the engine compartment.