Would this vacume hose being off have anything to do with not getting any response from my auto gearbox on my 97 2.6lt rodeo ? i go through gears & it not responding?

Question 1

0helpful

1answer

Hello I have problem with scania r420 auto manual gearbox gear 1is normal gear2 is not going gear3 normal gear4 is not going gear5 normal UpTo gear12

If you are experiencing issues with the gearbox on your Scania R420 where gear 1 and 3 are working normally, but gear 2 and 4 are not engaging properly, it is likely that there is a problem with the gearbox itself. Here are a few potential causes for the issue and steps you can try to troubleshoot:

Synchronizer ring: The synchronizer ring is responsible for coordinating the speed of the gear with the speed of the engine. If the synchronizer ring is worn or damaged, it may prevent gear 2 and 4 from engaging properly.
Clutch: The clutch is responsible for connecting and disconnecting the engine from the gearbox. If the clutch is worn or damaged, it may prevent gear 2 and 4 from engaging properly.
Linkage: The linkage is responsible for connecting the gear lever to the gearbox. If the linkage is worn or damaged, it may prevent gear 2 and 4 from engaging properly.
Control module: The control module is responsible for controlling the gearbox. If the control module is malfunctioning, it may prevent gear 2 and 4 from engaging properly.
Check the oil level and condition: Make sure that the oil level and condition are correct. Low oil level or dirty oil can cause damage to the gearbox and prevent gear 2 and 4 from

Jan 19, 2023 • Cars & Trucks

1helpful

1answer

Thanks Bill for the quick responce..i will advice my engineer to remove and re fix the gearbox back,maybe it will work better....but if not,..does changing from auto gear to manual requires changing the...

When changing from auto to stick shift, don't forget to install a pilot bushing into the rear of the crankshaft. It's a real bummer when you do everything else right and forget this small part...ask me how I know!

Dec 29, 2014 • Cars & Trucks

0helpful

1answer

I have a vacume leak n cant find ir it is hissing behind the motor on drivers side. i need a diagram where the vacume lines should be.

Auto Zone, or others, have a book called a Haynes Manual, that has all of the diagrams and schematics with instructions and pics on how to fix just about anything on your model vehicle.

Oct 15, 2013 • 1994 Isuzu Rodeo

0helpful

1answer

Need a diagram for vacume hoses

Get a Haynes manual from Auto Zone or others, that has the diagrams and schematics that you need.

Oct 15, 2013 • 1994 Isuzu Rodeo

1helpful

1answer

1997 Ford Windstar

It could be the vacuum modulator on your auto transmission, sometimes when vacuum hoses fail,split or whatever, they can suck up impurities causing other downstream items to fail. Also check mechanical linkage form shifter in cabin to transmission gear selector arm. If jumps were happening these might have worked loose. Best of luck!

Jan 04, 2013 • Cars & Trucks

0helpful

1answer

I have a 1995 3.1 diesel *** Isuzu MU with auto transmission. The gearbox will not engage top overdrive gear and the check transmission light for the OD is constantly flashing.

I have a Isuzu Mu Wizard from 1992 with gear problems. The box is automatic. When I put it in the lock I seem to have the box locked. the box makes a lot of noise when locking. What do I do to solve it?

Apr 24, 2011 • 1995 Isuzu Rodeo

1helpful

1answer

Car starts rough idles very low almost dies while idling and will die when put in gear. will not accelerate up hills (loses power). have been told there are many vacuum leaks and the transmission will...

your vacum leaks has alot to do with it have vacum leaks fixed auto parts store sells the correct size hose you need at a ver fair price fix vacum leaks first then see how it runs after thatcheck fluid level in transmission and change transmission filter

Dec 23, 2010 • 1990 Cadillac SeVille

1helpful

1answer

Jaguar S-type (2000 auto) gearbox fault when on motorway

It sounds like the tranny is over heating, you might want to have the tranny check by a pro. Way to complex to work on with out experience and training.

Jun 12, 2009 • 2000 Jaguar S-Type

0helpful

1answer

Hyundai Coupe gearbox ( not car in product)

hi there! i was a master tech 4 hyundai, first of all has the atf fluid been changed and at the correct level. or have you had the multifuntion switch checked? please feel free to contact myself and i will advise you as required with my exsperience

many thanks

Dominic Hill

Dec 09, 2008 • 1998 Hyundai Elantra

0helpful

2answers

1994 automatic transmission slipping

more than likely it would be your torque converter and not your trans
but you could have the overall dreaded problem that your second gear has grinded its self down and thats why you cant get second gear
no vacumes for the 94 straight mechanical and electrical if there was a vacume you would have found it when you dropped the pan it isnt hard to see around the whole trans cause it would be located next to the speedo with a rubber hose 1/4 thick

Dec 06, 2008 • 1994 Isuzu Rodeo

Question 2

Bill Boyd

Cars & Trucks Master 53,816 Answers
Posted on Dec 14, 2015

Bill Boyd

Cars & Trucks Master

Joined: Jan 04, 2013

Answers

53816

Questions

7

Helped

11949641

Points

172802

NO
the vacuum hose to the transmission actuator is a small hose from the manifold down to the top of the transmission
the hose you have off is from a brake booster or PCV unit

Answer 2 · 7/16/2008 12:00:00 AM

A

Anonymous

Posted on Jul 16, 2008

SOURCE: 1999 a4 2.4 auto uk model gearbox fault

After a jump start because of no electrical power, the car will run rough for several days (expected) while it adjusts to your driving habits. I'm not sure about the gears, but I'd try to drive with it like that for a few days and see if it returns to normal.

Anonymous

13 Answers
Posted on Dec 11, 2008

SOURCE: Hyundai Coupe gearbox ( not car in product)

hi there! i was a master tech 4 hyundai, first of all has the atf fluid been changed and at the correct level. or have you had the multifuntion switch checked? please feel free to contact myself and i will advise you as required with my exsperience

many thanks

Dominic Hill

Marvin

85242 Answers
Posted on Jun 14, 2012

SOURCE: Auto gearbox gets stuck in reverse gear.

This is likely a sticking valve in the transmission valve body assembly, try adding a can of Lucas brand transmission additive.

Testimonial: "Hi Dennis. Thanks for your solution have ordered parts to drain gearbox oil and replace filter in the sump, will add additive when I put it back. Thanks for your reply."

Answer 3 · 7/16/2008 12:00:00 AM

A

Anonymous

Posted on Jul 16, 2008

SOURCE: 1999 a4 2.4 auto uk model gearbox fault

After a jump start because of no electrical power, the car will run rough for several days (expected) while it adjusts to your driving habits. I'm not sure about the gears, but I'd try to drive with it like that for a few days and see if it returns to normal.

Answer 4 · 12/11/2008 12:00:00 AM

Anonymous

13 Answers
Posted on Dec 11, 2008

SOURCE: Hyundai Coupe gearbox ( not car in product)

hi there! i was a master tech 4 hyundai, first of all has the atf fluid been changed and at the correct level. or have you had the multifuntion switch checked? please feel free to contact myself and i will advise you as required with my exsperience

many thanks

Dominic Hill

Answer 5 · 6/14/2012 12:00:00 AM

Marvin

85242 Answers
Posted on Jun 14, 2012

SOURCE: Auto gearbox gets stuck in reverse gear.

This is likely a sticking valve in the transmission valve body assembly, try adding a can of Lucas brand transmission additive.

Testimonial: "Hi Dennis. Thanks for your solution have ordered parts to drain gearbox oil and replace filter in the sump, will add additive when I put it back. Thanks for your reply."

Related Topics:

Trustworthy Expert Solutions

Would this vacume hose being off have anything to do with not getting any response from my auto gearbox on my 97 2.6lt rodeo ? i go through gears & it not responding?

1 Answer

Bill Boyd

3 Related Answers

Anonymous

Anonymous

Marvin

Add Your Answer

Attachments: Added items

Related Questions:

Hello I have problem with scania r420 auto manual gearbox gear 1is normal gear2 is not going gear3 normal gear4 is not going gear5 normal UpTo gear12

Thanks Bill for the quick responce..i will advice my engineer to remove and re fix the gearbox back,maybe it will work better....but if not,..does changing from auto gear to manual requires changing the...

I have a vacume leak n cant find ir it is hissing behind the motor on drivers side. i need a diagram where the vacume lines should be.

Need a diagram for vacume hoses

1997 Ford Windstar

I have a 1995 3.1 diesel *** Isuzu MU with auto transmission. The gearbox will not engage top overdrive gear and the check transmission light for the OD is constantly flashing.

Car starts rough idles very low almost dies while idling and will die when put in gear. will not accelerate up hills (loses power). have been told there are many vacuum leaks and the transmission will...

Jaguar S-type (2000 auto) gearbox fault when on motorway

Hyundai Coupe gearbox ( not car in product)

1994 automatic transmission slipping

Not finding what you are looking for?

Cars & Trucks

Hello I have problem with scania r420 auto manual gearbox gear 1is normal gear2 is not going gear3 normal gear4 is not going gear5 normal UpTo gear12

Ask a Question

Check Out the Latest Top Trucks Report!

Top Cars & Trucks Experts

ZJ Limited

john h

Arnie Burke

Are you a Car and Truck Expert? Answer questions, earn points and help others

Manuals & User Guides

DIS9_Full.pdf. user-manual-1994...

DIS9_Full.pdf. user-manual-1994...

Rhonda_Docs.pdf. user-manual-2001...

Related Topics:

Trustworthy Expert Solutions

Would this vacume hose being off have anything to do with not getting any response from my auto gearbox on my 97 2.6lt rodeo ? i go through gears & it not responding?

1 Answer

Bill Boyd

3 Related Answers

Anonymous

Anonymous

Marvin

Add Your Answer

Attachments: Added items

Related Questions:

Hello I have problem with scania r420 auto manual gearbox gear 1is normal gear2 is not going gear3 normal gear4 is not going gear5 normal UpTo gear12

Thanks Bill for the quick responce..i will advice my engineer to remove and re fix the gearbox back,maybe it will work better....but if not,..does changing from auto gear to manual requires changing the...

I have a vacume leak n cant find ir it is hissing behind the motor on drivers side. i need a diagram where the vacume lines should be.

Need a diagram for vacume hoses

1997 Ford Windstar

I have a 1995 3.1 diesel *** Isuzu MU with auto transmission. The gearbox will not engage top overdrive gear and the check transmission light for the OD is constantly flashing.

Car starts rough idles very low almost dies while idling and will die when put in gear. will not accelerate up hills (loses power). have been told there are many vacuum leaks and the transmission will...

Jaguar S-type (2000 auto) gearbox fault when on motorway

Hyundai Coupe gearbox ( not car in product)

1994 automatic transmission slipping

Not finding what you are looking for?

Cars & Trucks

Hello I have problem with scania r420 auto manual gearbox gear 1is normal gear2 is not going gear3 normal gear4 is not going gear5 normal UpTo gear12

Ask a Question

Popular Questions

Toyota dashboard CD player won't eject

4.3 Firing order diagram for 4.3L v6 Chevy engine

BMW X5 Trans Fail Safe Program,

Diagram of 1996 ford ranger fusebox which fuse is

What does my check engine light trouble code $7e8 mean?

Check Out the Latest Top Trucks Report!

Top Cars & Trucks Experts

ZJ Limited

john h

Arnie Burke

Are you a Car and Truck Expert? Answer questions, earn points and help others

Manuals & User Guides

DIS9_Full.pdf. user-manual-1994...

DIS9_Full.pdf. user-manual-1994...

Rhonda_Docs.pdf. user-manual-2001...