As far as i know you do not bleed power steering pumps. you fill them and start the car and turn steering wheel from lock to lock
SOURCE: How to install the front license plate on the 2008
There should be guide holes in the bumper for you to mount the plate. It's recommended to mount a backing piece and then mount the place onto the backing for sturdiness. If there are no holes, you can just screw two holes into the bumper
SOURCE: location of cabin air filter
It can have a cabin air filter, but most vehicles ship without it.
Either way, you can access the cabin air filter housing by opening the glove box all the way (squeeze the sides so it clears the stops).
The filters are around $15 at the dealer.
Whether or not there's a cabin filter installed, make sure you're also
following Chrysler's recommendations in the owner's manual—running the
air on recirculate all the time will encourage mold and bacteria to
grow.
Good luck
SOURCE: power stering, changed the pump but still not
The whole power-steering assembly itself is the next thing to look at. I think it is defective, and could be replaced for a rebuilt one.
SOURCE: like to know what tipe of antifreeze 2008 jeep
Your Jeep uses a H.O.A.T engine antifreeze that is pink in color. It is not recommended that you mix any other type of antifreeze with the H.O.A.T. Any Chrysler, Dodge or Jeep dealership stocks this type of antifreeze and it is sold already mixed with water. The cost is around $14.00 a gallon.
Do Not Mix any other antifreeze.
189 views
Usually answered in minutes!
Keep adding fluid while turning steering left and right until it stops taking the fluid and set level on max on reservoir
×