Question about 2005 Ford Focus ZX4

Open Question

How to change a headlight in a 2005 ford focus zx4

Is there anyway that the headlight can be changed without taking things apart on the drivers side

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
airjoc
  • 709 Answers

SOURCE: broken rear wheel stud on a 2005 ford focus zx4 se

  1. Step 1 Buy a new stud. Make sure you purchase the right size. If you're not sure what size to get, wait until you remove the stud and take it with you to the store.
  2. Step 2 Check the area of the spare tire in the trunk for the jack and the jack tools since you'll need to raise the car to replace the wheel stud on your Focus. Be sure to block the tire diagonal to the jack.
  3. Step 3 Use the jack to raise the Focus. Remove the wheel Take off the caliper and either hang it by a mechanics wire or lay it up so it doesn't dangle by the brake line. Remove the rotor. If you're working on back wheels, you have to remove the emergency brake clip first. You could have drum brakes in the rear. If they're drum brakes, remove the drum.
  4. Step 4 Hunt for an opening behind the hub that allows you to remove the stud. Line the stud up with the hole. You may have to take off the hub and put it in a vise if you can't drive it out the back.
  5. Step 5 Hit the stud with a mallet and drive it out the back of the hub. Push another stud into the opening. This is tough work, but you only need to push it far enough to thread on a wheel bolt.
  6. Step 6 Put on a wheel bolt and begin to tighten it. As you do, the stud starts to pull through. Add more bolts as necessary until you seat the stud. Check in the back of the hub. When the head is flush with the stud, you seated it.
  7. Step 7 Remove the extra bolts and reassemble the parts that you took off to replace the wheel stud on the Ford Focus. Put the wheel back on the vehicle and tighten down the wheel nuts.

Posted on Sep 25, 2009

Ad
BCAS1298
  • 3092 Answers

SOURCE: I need serpentine belt diagram for 2005 ford focus

IF YOU GO TO ANY AUTO PARTS THEY WILL BE MORE THEM GLAD TO GIVE YOU THAT INFO. AUTO ZONE WILL DO THAT FOR YOU.

Posted on Nov 04, 2009

SOURCE: how do i clear fault codes in my srs module

with a scanner, no way to do it without the proper tools

Posted on Nov 27, 2009

  • 1168 Answers

SOURCE: what type of antifreeze is used with a 2005 Ford Focus

Hello mk12x.

Ford specification is Motorcraft Premium Engine Coolant VC-4-A (in Oregon VC-5, in Canada CXC-10) or equivalent meeting Ford specification ESE-M97B44-A (green color) with a mix of 50-50 coolant and clean water.
I hope your repair goes well for you.

Kl

Posted on Dec 17, 2009

  • 204 Answers

SOURCE: how to remove the alternator

Its a big job and requires time, patience(try not to throw tools around), and following the step by step instructions from a Haynes/Chiltons manuals.
Good luck.

Posted on Feb 03, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i remove a dash on a 2005 ford focus zx4?


there is going to be a whole lot of screws, take a few pitchers as you go unless you can remember everything from start to finish take the battery connections off then you can get going, take the glove box out,kick panels off drop the steering column down but don't pull it out just unbolt it remove the center console, just pay Attention to how you take the dash apart.

Dec 15, 2016 | 2005 Ford Focus ZX4

1 Answer

My 2005 ZX4 focus is making a loud sound from the exhaust. It sounds like it is coming from the front end of the car.


sounds like the flex pipe it's a steel braided exhaust part that allows the engine to move back and forth these are a common problem moisture will sit in the accordion parts and they rot from the inside out and they will usually look fine at first glance unless the braids are starting to pull apart

Jul 25, 2016 | 2005 Ford Focus ZX4

1 Answer

I got a zx4 2005 ford focus that will not engage when I put it in to gear. What can I do?


broken cable. try operating the gearshift while looking for the operation on the transmission itself. raise hood and observe the transmission.

Apr 16, 2015 | 2005 Ford Focus ZX4

1 Answer

I have a 2005 Ford Focus zx4 changed passenger headlight bulb but still not working what fuse should I check to see if that is the poblem


i am not sure, but i would recommend you to first check first the connector plug for any built up corrosion, and if the wires are in good condition.

Feb 09, 2015 | 2005 Ford Focus

1 Answer

2005 SE ZX4 ford focus


It's a problem inside the transmission. Could be as easy as a fluid and filter change. Could be the solenoid package.

Aug 30, 2014 | 2005 Ford Focus

1 Answer

Where is fuse for trunk


The fuse box of the 2005 Ford Focus is located on the driver's side, below the dashboard. It is mounted on the firewall just to the left of the brake pedal. ---------------------------------------------------------------------------
Diagnostic VAG

Dec 17, 2012 | 2005 Ford Focus ZX4

1 Answer

At night, my drivers side headlight beam is higher & brighter than my passengers side one. i have changed both headlight bulbs (bought from small car parts shops, and not halfords or ford). do i need...


yes you need to adjust it find a wall that you can see both beams and do the adjustment neccesary and your on your way common when roads are not the best or you hit something lightly the headlights change position

Apr 04, 2010 | 2005 Ford Focus

3 Answers

How do i clear fault codes in my srs module for a 2005 ford focus zx4?


with a scanner, no way to do it without the proper tools

Nov 27, 2009 | 2005 Ford Focus

1 Answer

How to I replace an electric drivers side mirror on a Ford Focus


Go to a breakers yard or ford, you will have to unscrew & pull off the interior cap on the insde to udo the mirror whole unit & pop the glass out of the old unit by pulling carefully, then disconnect the motor & wiring, then re-fit as dismantled.
Hope this helps, If you can't do it yourself then buy the mirror & take it to a decent garage as they are not hard to replace & the dealership will charge twice as much !
Hope this helps !

Sep 22, 2009 | 2005 Ford Focus

1 Answer

Can i change my sparkplugs myself?


You will need a spark plug wrench amongst other things, but it should be fairly cheap. It may be worth seeing how cheap it is at the auto shop, since it shouldn't take long. It may cost about the same as the instruments needed.

Here is a step by step guide if you want to do it yourself.

Hope this answered your question. Please rate accordingly.

Nathan.

Apr 14, 2009 | 2005 Ford Focus

Not finding what you are looking for?
2005 Ford Focus ZX4 Logo

Related Topics:

96 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

84027 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22483 Answers

gerry bissi

Level 3 Expert

4387 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...