An expert who has achieved level 2 by getting 100 points
An expert that got 5 achievements.
An expert whose answer got voted for 20 times.
An expert who has answered 20 questions.
Re: 2002 Jaguar dash panel removal
Fist disconnect the battery and inside the clovebox is the airbag senser unpluge is and then remove the screws around the bottom of dash there is also clips that help hold it on. be carfull not to pull to hard for the wires inside dash.
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones). click here to download the app (for users in the US for now) and get all the help you need. Good luck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Its located at the front center of the engine (it have Jaguar logo), you need to remove 3 screws of the large panel and the oil cap, remove this large panel and then remove other 6 screws of the air filter box.
You must open the center console lid and remove the 2 Phillips head screws above the fuse station to expose the ashtray Phillips head screws.Remove the ashtray screws and carefully pull he ashtray back towards the center console. After the ashtray is removed take your hand an feel under the wood grain unit for the 2 plastic wing nuts holding the wood grain in place. Remove them and gently lift the wood grain up and out of the way. Remove the 4 Phillips head screws holding the AC controls and Radio bracket. Place the gear shifter in drive to pull the whole unit out. Sounds like a lot but takes about 10-15 mins to complete.
You'll need to remove screws that are by the door handle,
arm rest, under door and side of door and then gently pull back on the
panel as there will also be retaining clips attached and you don't want
to break them. If needed, you can pull back the weather seal
(can't reuse it, but it's not that important) and you will be able to
access everything inside the door
Hello, To the rear of the wood grain where the switches are, you should have a small piece of carpet that you just pull up and get it out of the way. You should see 1 screw. Remove the screw and gently pull up on the back of the wood grain. Now you will be able to change the switch. I hope this helps. CYA, Gator241
There are 2 types of wood trim on the s-class. One is a solid piece and the other is split in the middle. Remove the ac pushbutton panel, remove the shifter trim and remove the cigar lighter insert. If it is a solid panel, then you will unscrew two screws underneath where the ac panel was and I believe that with the ac panel out of the way you can reach in and pull the radio head out. If you need to remove more, then be very careful with the wood-very costly. If it is the split wood, look for a screw on the back of the cigar lighter wood trim(you've already removed the insert, right). You need a 1/4 in. ratchet with a screwdriver bit to access. You only need to loosen it up and slip it off. With the wood out of the way, look for two hidden screws on the inside front edge of the center console wood panel-right behind the wood cover you just removed. These will have to come out as well. Once they are out, pull up gently on the front of the rear wood panel(around the shifter) and slip out, There are likely two more screws underneath this panel. Take them out to remove upper wood trim.