Question about 2001 BMW 325
Posted on Apr 22, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
hi i have a diagram if you would like it i could email it to you and there are 2 of them does it say which one it is? you can email me at
and i will send you the diagram hope this helps
Posted on Mar 21, 2010
I am assuming that you have a burned out head light bulb.
1) Open hood.
2) Working in back of headlight assembly, grasp rear of bulb socket (harness connector) and turn counterclockwise 90 degrees. Pull bulb out of headlight assembly.
3) Disconnect harness connector from bulb (gently pry, it's plastic)
4) Installation is reverse of removal. (Do not touch halogen bulb with bare skin-oils from hand will cause bulb to burn out.) Align tabs on bulb base to cutouts on rear of lens assembly. (Note bottom tab is wider than other two) Secure bulb by rotating clockwise 90 degrees.
Low beam bulb H9006
High beam bulb H9005
Posted on Jan 23, 2009
It is located under the water pump. Make sure when you remove the sensor that you rotate the crank shaft and look in the hole to make sure the pick up magnet is still in there. Sometimes they come loose and cause a no start or long crank. You will need to have the code cleared still.
Posted on May 06, 2009
Tips for a great answer:
Nov 01, 2016 | Cars & Trucks
May 21, 2015 | Cars & Trucks
May 25, 2014 | 1996 BMW 328i
Apr 25, 2014 | 1994 BMW 3 Series
A camshaft position sensor,or cylinder identification sensor is used to determin the engine cycle position the information is used to provide individual cylinder ignition and injection cotrol.Many engine mangement systems use an inductive type of sensor that is located near the camshaft;when the camshaft rotates a single signal is passed to the ECU to indicate a reference point in the engine cycle
May 03, 2011 | 2003 Chevrolet Malibu
Jan 12, 2011 | 1996 BMW Z3 Roadster
Nov 11, 2009 | 1991 BMW 5 Series
Sep 15, 2009 | BMW 325 Cars & Trucks
Aug 26, 2009 | 2000 BMW 3 Series
Aug 05, 2009 | BMW 528 Cars & Trucks
2,035 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: