Question about 1990 Toyota Corolla

1 Answer

Car won't start all the time without a manual how do I find the solinoid?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Toyota Master
  • 358 Answers

It is on the starter on the back side of engune below the intake manifold

Posted on Jul 14, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Won't start


sounds like a bad ground to your solinoid its not the starter try tapping the solinoid

Nov 25, 2012 | 1988 Toyota Pickup

1 Answer

My 2002 dodge caravan won't start


How about the start solinoid? Try jumping the large terminals with a large screw driver and see if it turns over if so make sure there is 12 volts on the coil of the soinoid when you turn the key, if so replace the solinoid.

Nov 01, 2012 | Dodge Cars & Trucks

1 Answer

When trying to start my 1999 GMC Jimmy I turn the egnition and all my aux. lights turn on and everything works, but there is no power going to my starter, it doesn't make the clicking sound and it...


check for power to starter solinoid, if power to there. then it has to be a bad starter solinoid or starter. checker solinoid first. if bad you will not hear any clicks or anything.

Sep 11, 2011 | 1999 GMC Jimmy

2 Answers

I have a 2004 pontiac sunfire with a few problems. First, when I turn the ignition to start the car all I get is a fast-paced clicking sound from the dash area and the engine doesnt even turn over. This...


as fo the idle, there is a IAC ( idle air control to maintain idle. you may have to remove this and clean the carbon out of it, and the intake as well. as for the clicking there are 3 solutions to fix it. battery if it is ok, the solinoid is bad on starter or the starter itself. but it does sound like a bad starter solinoid, because a bad battery will make the same clicking from solinoid. but make sure battery is ok first. when engine is off voltage at battery should be at least 12.6 or better. when running and alternator is ok, it should read about 14.2 to 14.7 if lower then 14 volts alt. is bad. have a very good day !! hope this helps!

Jul 09, 2011 | 2004 Pontiac Sunfire

1 Answer

Have a 98 ford explorer and it won't start tryed to jump it nothen. Put a starter in and still won't click ove it sounds like it dead but if I play with the power distreber box I'm dash lights...


it could very well be the starter solinoid mounted on fender under hood. most fords are setup this way. to test it -- You could use jumper cable to jump the two large studs on the solenoid together, which should make the starter crank the engine, assuming the engine can rotate freely. If jumping the solenoid works, then the solinoid is probably bad. have a good day !!

May 06, 2011 | Ford Explorer Cars & Trucks

1 Answer

90 vette, ZR-1, Engine won't crank. Solinoid won't click. Worked fine since new. Washed engine, started & drove into garage, 2 days later won't crank. Has 30,000 miles, owned since new. Batt....


Never wash engine in zr-1,starter is in center of engine,drain hole is usually plugged up,starter has shorted out,will need new starter,clean drain hole out when it is changed

Nov 06, 2010 | 1990 Chevrolet Corvette

2 Answers

No noise when i turn key battery is fine where is


on most fords the solinoid is mounted under hood on passenger side. follow battery cable to solinoid, to test solinoid, put a jumper accross the neg, and pos, terminals on solinoid. if the car starts, then the solinoid is bad.if not check cables to starter. hope this helps toolman,

Feb 15, 2010 | 1998 Ford Windstar

1 Answer

After starting my 91 camaro the starter enguage wheel won"t stay pulled back out of the way. How do I fix this?


Replace the starter you will or have damaged the starter drive and could ruin the teeth on the fly wheel. The spring has gone bad in the solinoid or the shaft thats is activated magnetically is dirty and sticking, ther could be a problem with the starter switch but that is less likely than the solinoid.

Oct 17, 2009 | 1991 Chevrolet Camaro

Not finding what you are looking for?
1990 Toyota Corolla Logo

Related Topics:

70 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...