Question about 2000 Pontiac Montana

2 Answers

2000 pontiac montana power window|locks doesnt work but the fuses are good and wiring to doors is good

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 3 Answers

I had a 99 with the same problem, and suggest you check under the passenger side front carpet. Remove the flat door kick plate, lift up the carpet on the front passenger side floor and you will see a large wiring harness running along the floor, wrapped in black tape. Water and salt gets into this harness and will rot out several wire splices that you will see. Look for wires that run from 2 wires down into one (under black tape.) These are spliced together, and rot out. There was several large gauge wires/splices(windows up and down) and I think 2 very thin wires/splices (lock/unlock) . Even if the wires look connected, give them a good tug, they will come apart and be green with corrosion. This is a very common problem and worth the effort to check out. Repairing these splices fixed both the power windows and locks at the same time. Good luck

Posted on Aug 15, 2009

  • renzolema25 Aug 10, 2013

    i can resolve the unlock problem but the passenger window doesnt work 2000 Pontiac montana Minivan 114.000 k miles

×

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 22 Answers

Like i said in other post, 95% of the time the left hand power window switch is the problem. simply pry the trim off from the pointy end of it and change switch.

Posted on Jul 17, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 pontiac montana power windows stopped working ,checked fuses,all good ,checked voltage all good except where the up/down switch is the voltage is1.5 it reads 3.5 then goes down 1.5 .any suggestions?...


Manual window crank changeover would mean a different regulator and door panel for each door. It's very common for the wire harness between the A-pillar and the door frame have damaged wires, particularly the system ground wire.Really need to check that circuit! You can supply your own ground to the switch and recheck the operation just to verify and eliminate the harness as an issue.
If you have full battery voltage and a good ground circuit to the pin connector on the master window switch, then it's probably just the switch and the dismantler near you should have one for less than $20.

May 06, 2014 | 2000 Pontiac Montana

1 Answer

No power to my front windows all fuses are good


check that the switch that locks the window switches is on. It is a small switch not far from the switch set in the drivers door.

Feb 18, 2014 | 2000 Pontiac Montana

1 Answer

My 2003 montana door locks quit workin along with my rear widows.Had checked fuses but did not seee any probs.Door locks will operate with remote but not on the switch.Not sure which relays to check,but is...


check the wire harness under carpet just inside front pass door sill.Look for the white(unlock) and light blue(lock) wire splices and check for corrosion.

Apr 15, 2011 | 2003 Pontiac Montana

2 Answers

Power window (drivers side) quit working on my 2000 Pontiac Montana. Can't be a fuse issue as the passenger side still works. Any ideas on a fix?


More than likely just a faulty switch. Sometimes you can take them apart and clean them. Or, just go to an auto wrecker and get another one.

Mar 20, 2011 | 2000 Pontiac Montana

1 Answer

Power door locks, and power side windows wont owrk


check wiring at drivers door hinge inside protectve loom,should find broken wiring

Oct 04, 2009 | 2004 Pontiac Montana

1 Answer

No power windows door locks interior lights or key chimes


try checking the pin switches in the door jambs if you have no power to these items with the door open i would lean toward the pin switches being stuck or bad ground or broken not an uncommon problem

Jul 14, 2009 | 2000 Pontiac Montana

1 Answer

04 pontiac montana sliding doors no longer work


the sliding doors on montana assuming there power have a electrical harness on the bottom track that break and jam the doors but unlikly both have this problem do the doors lock @ unlock if not check switch at drivers door

May 27, 2009 | 2003 Pontiac Montana

1 Answer

I have a 2000 pontiac montana When it rains


WATER IS COMING AROUND WINDOW MOLDING CHECK FOR LOCATION,USE A BOTTLE OF WATER.

May 07, 2009 | 2000 Pontiac Montana

1 Answer

Power windows front and rear dont work


inside the door panel for the module ,speedo lights and fuel gauge is another problem

Mar 28, 2009 | 2000 Pontiac Montana

Not finding what you are looking for?
2000 Pontiac Montana Logo

1,198 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...