2009 Dodge Journey Logo

Related Topics:

f
fatime Posted on Nov 21, 2015

Why won't stereo load any disc?

It says enter 1-6 discs, but it doesn't let them go inside. When I press eject, it says there aren't any discs inside.

1 Answer

Kristen Bradley

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

  • Contributor 1 Answer
  • Posted on Jan 23, 2016
Kristen Bradley
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Joined: Jan 23, 2016
Answers
1
Questions
0
Helped
1312
Points
1

I also have a 2009 Journey with the 6 disc changer. There is a 'LOAD' button to the right of the disc opening. Press 'LOAD' and wait for it to display "insert disc". The 'EJECT' button is on the left side (above the power knob) and the 'LOAD' button is on the right (above the volume knob).
Hope this is helpful.

2 Related Answers

Molson02536

Harvey N Tawatao

  • 3854 Answers
  • Posted on Oct 30, 2009

SOURCE: cd stuck in stereo

Turn the radio off, disconnect the battery for 2min then reconnect the battery. the radio should reset it self for you to eject the CD and just reprogram the time and radio presets. Note you must make sure the radio is off when battery is disconnected or your going to be prompt to enter a radio code to have it work again. Good luck and keep me posted, if this does not work, then your CD player motor has gone bad and your going to have to replace the radio.

Ad
duane_wong

Duane Wong

  • 6826 Answers
  • Posted on Jul 17, 2010

SOURCE: We can't get the factory 6 disc cd player to load

The following is the owner's manual for your 2004 Dodge Neon:

http://www.dodge.com/en/owners/manuals/index.html?year=2004&nameplate=Neon

P.99 describes how to load discs:

1. Select and press any numbered button without an illuminated light above it.
2. Insert the CD while the light above the chosen button is flashing and the two lights on either side of the slot are illuminated.
3. Upon insertion, the CD will begin to play, and both the button light and the lights in the corner of the loading slot will illuminate.
4. Repeat the process for loading any additional CDs. The CD playe rwill stop while additional CDs are loaded.

Playing Discs
The radio will show the CD number, the CD track number, and the Track Time Elapsed while the radio is in the CD mode. IF more than one CD is loaded in the changer, the changer will automatically play the next disc after playing the last track of the current disc.

Wow, that's a lot of typing.
I didn't know the 2004 Dodge Neon had such a nice changer.
Good luck.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

My disc will not load in my new vx 7020 jensen navigation care stereo. its new.

Even new is defective some times. If everything works on the stereo, except the disc player. return it.
1helpful
1answer

My 5 disc CD changer will not eject an hung CD , on an Infiniti 2005 G35,..any solutons???

Some CD players actually have a locking mechanism inside of them. This mechanism can be released by using an unwound paperclip and sticking it into the CD player. There should be a button or platform to push that could release the disk. If that doesn't work, you might want to try using a pair of tweezers to pull the disc. To do this put the tweezers inside the CD tray and try to pull the disc out while pressing down and holding the eject button on the CD player. To me, it sounds like the motor that sucks in and ejects the disc is slowly dying and is having trouble pushing the disc out. If all else fails you might want to take the car to a dealership to see if they can replace your CD player
0helpful
1answer

My Ford Explorer 6 disc cd has 1 cd stuck in it and it won't eject, play or let me load other cd's. How do I get the cd out?

take the radio out and take it apart and move the sensor out of the way and take the CD out you might have to replace the CD sensor
0helpful
1answer

I have a 2004 Mazda 3 w/ a single disc CD player...which has not been working for several months. There is a cd in the player but nothing happens when I press the eject button nor the CD button; won't...

Possible that the cd disc has jammed due to a change in the disc- warming can bend some cd's, also if the cd is struck inside as the loading mechanism is struck. In both cases the set must be pulled out if there is no hope with trying to retrieve the cd softly assisting while ejecting. If you do not hear any noise while the eject is pressed then the loading drive is faulty , you need to remove the cd , open to check, If this is mechanical then you can softly push the cd out, if not the electonic section needs a check.
0helpful
1answer

My Honda accord Sedan car CD Player cannot eject CD .

Before connecting any cables you must set the dip switch box to the position listed for your vehicle. If you set the dip-switches after you have connected cables to the box, you must disconnect and reconnect them for the changer to operate. All 1992-2004 Honda's are compatible with the Neo Changer except the 2003 and 2004 Honda Accord and all Honda Element vehicles. Some radio models require pressing "Seek >" once to start playing after changing CD or after startup. The radios display will not show the proper disc number after disc six. You can use all 10 discs in the magazine, but the readout will be wrong. This is not a technical problem; the car stereo was designed for no more than six discs. *Due to the direct access disc system, you will not be able to directly access discs 7-10. To access these discs you will have to go to the last track on disc 6 and let it play until it loads disc #7. ( you can fast forward the track, but you must let it play the last 5 seconds of the track, for it to change to disc # 7 Switch to the Neo Changer by pressing the "CD" button. To change discs press "Disc -" and "Disc +" To change tracks simply press "Seek <" or "Seek >" S E T T I N G S F O R H O N D A 1 2 3 4 5 6 7 8 ON OFF OFF ON OFF OFF ON OFF
12helpful
1answer

6 disc changer will not eject cds==

One common solution is to disconnect the negative battery cable for 10minutes. When you reconnect, the stereo should reset itself and allow you to eject your CD's . Best of luck!
Greg
0helpful
1answer

MINI: Trying to eject non-existent CD

I have only seen this problem once and the only fix was to replace the cd player. I would suggest to get an aftermarket cd player from electronics store and have them install it. The factory option is over 700 installed. sorry
1helpful
1answer

Nav system

Installing the DVD Map Disc Your dealer/retailer may have installed the map DVD. If the map DVD was not installed, do the following to load it:
Read the following steps completely.
  1. Turn the ignition on. The vehicle must be in P (Park) to perform this operation.
  2. Press (power) to turn the navigation system on.
  3. Press the NAV hard key.
  4. Touch the Insert Map Disc screen button. The screen opens to access the map DVD slot.
  5. Load the map DVD partway into the slot. The system pulls it in. The screen cannot be closed until a double beep is heard.
    Notice: Pressing directly on the navigation screen may cause damage. Repairs would not be covered by the vehicle's warranty. Do not press directly on the navigation screen.
  6. To close the screen, slightly push up on the two outer corners until the screen is in position. Then push the screen in by pushing on the four outer corners until a click is heard.
  7. Set the search area. See "Setting the Search Area" earlier in this section.
Ejecting the DVD Map Disc The navigation portion of the system cannot be used if the DVD map disc is not loaded.
  1. Press the MENU key to enter the Menu options, then press the MENU key repeatedly until Nav is selected or touch the Nav screen button.
  2. Touch the Map Database Information screen button.
  3. Touch the Eject Map Disc screen button. The screen tilts, exposing the map DVD slot.
  4. Press the eject button, located next to the DVD map disc slot, and the disc ejects. Pull the disc out. The screen cannot be closed until a double beep is heard.
    Notice: Pressing directly on the navigation screen may cause damage. Repairs would not be covered by the vehicle's warranty. Do not press directly on the navigation screen.
  5. To close the screen, slightly push up on the two outer corners until the screen is in position. Then push the screen in by pushing on the four outer corners until a click is heard.
Not finding what you are looking for?

1,322 views

Ask a Question

Usually answered in minutes!

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...