2007 ford escape location horn relay

Relay 23, and Fuse 34

Ford Focus (1999-2007) fuses and relays

https://fuse-box.info > ford > ford-focus-1999-2007-fu...
The fuse panel is located below and to the left of the steering wheel by the brake pedal (behind the cover). The location of the fuses in the passenger ...

2007 Ford Focus Fuse Diagram - Rick's Free Auto Repair Advice

https://ricksfreeautorepairadvice.com > ... > Fuses > Ford
Apr 28, 2018 - This 2007 Ford Focus Fuse Diagram shows two fuse boxes; the Battery Junction Box located under the hood and the Central Junction ...

..

It is located in the SJB - smart junction box an it is a non- serviceable part . soldered to the board inside . Where do you hear the clicking noise coming from ? The SJB is located behind the left side kick panel .
SECTION 413-06: Horn 2007 Edge/MKX Workshop Manual DESCRIPTION AND OPERATION Procedure revision date: 10/30/2006 Horn The horn system consists of the following components:

• Horn switches (part of the steering wheel)
• Clockspring
• Horn relay (part of the smart junction box [SJB])
• Horn

For removal and installation of the steering wheel, refer to Section 211-04 .
For removal and installation of the SJB, refer to Section 419-10 .
Principles of Operation
The smart junction box (SJB) supplies the control and switched voltage to the horn relay (part of the SJB). When the horn switches (part of the steering wheel) are pressed, ground is supplied through the clockspring to the horn relay. The horn relay is then energized directing voltage to the horn and enabling the horn to sound. When the vehicle security system is armed, the SJB provides a momentary ground to the horn relay control side to indicate the system is armed, and an on and off ground when an intrusion is detected or the panic alarm is activated.
If your horns are not working ,you have a wiring problem or the clock spring is open . If the relay is bad the whole SJB has to be replace an the dealer would have to do that . Needs to be programmed ,with factory tool .
Symptom Chart Condition Possible Sources Action

• The horn is inoperative

• Fuse
• Circuitry
• Horn
• Clockspring
• Steering wheel switch harness
• Horn switches (part of the steering wheel)
• Smart junction box (SJB)

• Go To Pinpoint Test A .

You

The relay is located in the under hood fuse / relay box . Marked HORN PCB relay , If you change it out an horn still doesn't work ,you can test to see what is missing right at the relay . Two of the pins at the relay socket should have battery + , one should be open an the other should show ground 0 ohm's . If you look on the side of the relay there is a diagram of the pins. 30, is Battery +, 87 goes to the horn . When you push the horn button on the steering wheel it causes the relay coil to energize closing the contacts in the relay sending power from pin 30 to pin 87 down to the horn turning it on ! Pins 85 an 86 are the control side , one should have battery + an other should be open , till someone pushes the horn button . You can test for power with volt meter an test with ohm meter for ground on the one , an a open on the other one, an have someone push the horn button an it should change to 0 ohm's .

Try changing the coolant sensor u can test it with a continuity tester

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/joe_0ca6379e2eceb740

see the diagram attached.God bless you

using a test light have someone push the horn and see if the light illuminates at the horn connector if it does its the horn assembly if it doesnt it could be at the steering wheel or a broken wire in between the steering wheel and the horn

images for 94 ford ranger horn relay location and

the horn is located behind front bumper bracket, when you locate it remove and try cleaning around the area where it bolts to as this i think is the earth for it

The horn is located on the drivers side below the headlight assembly. To remove it you have to first remove the bumper cover.You would need to remove the power distribution box to get access to the wires that go to the horn.
Thanks.Helpmech.

Hi!!
Check on the engine compartment fuse box by the battery, remove the plastic cap and look on the inside for the fuse location and description diagram. It should be labeled HORN. Check the Fuse first and then the Relay. To check the Relay, just swap it with another one with the same numbers on top of the relay. After testing, don't forget to replace the Relays to their original location. No need to turn key on since it is an Hot At All Time Circuit.
On some vehicles the Horn Fuse and Relay are located in the fuse box under Instrument Panel, driver's side.
Good Luck!! Don't forget to rate this post!!