Why when i push the button for my winshield my wipers work but no washer fluid comes out and i dont hear the sound like the motor is not running...can anyone help me?

Your hoses could be frozen if its cold where you are. Check the hoses for cracks. You might find fluid in your engine compartment if you have a broken hose. Listen to hear if the motor is pumping. There should be some sound either a click or a whiz sound when you push the washer button. If you hear no sound then check the wires on the pump. If they look good you probably need to replace the pump.

I had this problem last month. I was pushing the fluid button and was not hearing the motor. There could be two problems in this case. Either the unit in the steering wheel is malfunctioning, or there may have been non winter washer fluid in the pump and it froze and broke. In my case it was both, the button had to be jammed in to work, so the whole unit was replaced(turn signal and wiper control are together). The second problem was the the washer motor and is located on the drivers side, right under the washer fluid container. If you have parts laying around they are both very easy to fix.

if ur winshield washer fluid is low wipers wont run, check fluid if full then other issues

Push the washer fluid button and hold it for 20 sec then look under the truck and seeif you see the washer fluid dripping on to the ground, if theres no sign of the washer fluid then you have a bad washer pump, which is located on the side of the washer bottle, if theres fluid dripping then you will need to follow the line, start at the washer nozzles, this is where it breaks the most, if the line is plastic you can use a peice of rubber hose that size and connect the broken line back together with the hose, hope this helps.

WIPER FLUID LEVEL COULD BE LOW. ADD SOME MORE WIPER FLUID.IF FLUID LEVEL OKAY CHECK WIPER SPRAY NOZZLES COULD BE CLOGGED CLEAN THEM WITH A SMALL PIECE OF WIRE SMALL AS TINY PAPER CLIP WHICH CAN BE USED..

when you push the button you should hear something buzzing or whirring, if not look to the fuse, if the fuse is good then might be a bad pump

first and foremost, check that all your fuses are good. If they are, your next step would be to pull the winshield washer motor out and test it by applying 12 volts from the battery directly to the motor to see if it turns on. if it works then your problem is in the wiring, check that you are getting power to the harness when you turn it on. Now, if the motor does not work while applying battery power, then you need a new washer motor.

your rear wiper motor might be faulty,in the front i would check your fluid level-if it is full and you hear the pump running-check your washer lines to see if they are pinched-usually around where the hood closes

remove the hose from the wiper arm and see if when you push the washer button that the fluid comes out the hose,if it does the sprayer nozzel is plugged if not replace the pupm

can you hear the pump running.  If not check the fuses.  If you do and there is fluid.  Remove a hose from the back of the nozzle and se if fluid flows.  If so clean the nozzles with a needle as they plug up.