Question about 1996 Nissan Maxima

1 Answer

Antenna motor will not stop running - 1996 Nissan Maxima

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 721 Answers

The cable probably broke,easier to replace the entire assembly.

Posted on Jul 14, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Antenna motor will not stop running


No, I wouldn't pull the fuse then. But you could pull the electrical connector off at the antenna motor. Just have the antenna up if you want the radio, and pull off the antenna motor connector. When or if you get a new antenna motor for it, it should be an easy replacement. Look for a motor at a salvage yard.

Jul 07, 2012 | 1992 Pontiac Firebird

1 Answer

Is there a fuse you can pull to stop the antenna motor


Just unplug the cable at the antenna (pull back the carpet) IIRC the fuse the disables powers a bunch of others things also

Jan 01, 2012 | Cars & Trucks

1 Answer

1993 Buick Lesabre ...........antenna won't stop running and it's draining the battery.....can't find another motor assembly


For now would unplug it till you are able to find one.Sometimes all it is just the cable in the antenna mast that breaks and just may only require a new antenna to be installed and not the complete motor.

Aug 17, 2010 | 1993 Buick LeSabre

2 Answers

Power antenna motor won't stop running. Do you know where the cutout switch is located?


There is no switch. When the plastic gears inside the power antenna strip out they continue to run because the limiter switch inside the unit never gets tripped. If you can assist the antenna up when it's running, leave it up and disconnect the power to the motor. If i remember correctly the antenna is mounted on the passenger rear quarter panel. You should be able to pull some of the truck trim out a little and disconnect the two or three wire connector.

Jul 08, 2010 | 1993 Buick LeSabre

1 Answer

Antenna motor running. Antenna remains up even after engine is turned off. 1991 buick lesabre


Unplug relay at the bottom of antenna to stop the motor. Leave antenna up and keep on driving or replace antenna to watch it go up and down.

Mar 24, 2010 | 1993 Buick LeSabre

1 Answer

How to replace thunderbird antenna


please rate service.

Automatic Electric Antenna
Removal
  1. Lower electric antenna (18850) .
  1. Remove rear retaining screws of RH front wheel splash shield for access to antenna lower retaining bolt.
  1. Remove lower retaining bolt.
  1. Remove radio antenna nut (18865) from top of motor tube and remove electric antenna through fender/splash shield access.
  1. Disconnect signal cable and motor wire connector(s).
Installation
  1. To install, reverse Removal procedure.
  1. Tighten top radio antenna nut to 6-8 Nm (54-70 lb-in).
  1. Tighten lower electric antenna retaining bolt to 5.8-7.8 Nm (51-69 lb-in).
  1. Check operation of electric antenna and radio chassis .

    Automatic Electric Antenna


    1faf511.gif

mast
Mast, Power NOTE: A power antenna mast which is bent or broken can be replaced without replacing the motor and tube assembly.
Removal
  1. Remove radio antenna nut (18865) and radio antenna stanchion (18919) .

    ssd~us~en~file=l6389b.gif~gen~ref.gif

  1. Loosen retaining nut inside tube using 14 mm (9/16 inch) socket, and slide nut part-way up mast.
  1. Raise antenna to run plastic drive wire at bottom of mast out of motor. Note direction of teeth on plastic drive wire.
  1. Saw off damaged portion of antenna mast. Remove burrs from mast and slide nut and contact tube off stationary tube.
Installation
  1. With the teeth on the plastic drive wire facing toward motor on antenna, push end of plastic drive wire of replacement mast assembly down into tube. Push it around curve at bottom of tube until end enters drive mechanism.
  1. Run motor down while pushing on plastic drive wire until about 305 mm (12 inch) of wire has been drawn into the tube. Stop motor and insert bottom of antenna mast into tube. Lower mast.
  1. Slide contact tube and radio antenna nut down antenna mast. Tighten nut to 0.45 Nm (4 lb-in).

  2. Raise and lower antenna several times to ensure proper operation.
651247a.gif

Jul 09, 2009 | 1995 Ford Thunderbird

2 Answers

Power antenna motor will not shut off


I assume that the power antenna unit is an original equipment unit, if so.
1. Does it run for about a minute then stop? If this is the case, your antenna shaft needs to be replaced. This is a very simple procedure that your local radio install shop can do for you in about 20 minutes.
2. If the motor never shuts off as long as the key is on, you probably have a defective relay on the antenna motor. At this point you need to replace the entire unit. A job that can be a bit pricey because of the price of the unit itself. A cheeper fix is to replace the power antenna with a manually telescopic unit, (no motor), or a fixed unit, (doesn't go down). If you opt for the latter, remember to unscrew or lower the antenna in automatic car washes!

Jul 07, 2009 | 1984 Cadillac Eldorado

2 Answers

Antenna motor runs after car is shut off, without retracting the antenna. I have to disconnect my battery to stop it


Relay #27 in the box under the hood runs only the power antenna on a 1992. For the future here's the parts guide for everything in your jeep. Page 180 has a picture of what you want to pull.

http://jeepgarage.free.fr/OWN/1991-1993parts-catalog.pdf

Jun 02, 2009 | 1992 Jeep Cherokee Limited

Not finding what you are looking for?
1996 Nissan Maxima Logo

Related Topics:

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...