Question about 2003 Jeep Liberty

Open Question

2003 Jeep Liberty Check Engine light on continuously with no code. Airbag light on intermittently. Any ideas?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Mikey108
  • 475 Answers

SOURCE: 2003 jeep liberty air bag light on is it easy to fix

The system needs to be checked for cades. Airbag codes are pulled out of the ECU with the use of a scanner tool. A good auto mechanic shop will have this or you can go to the dealer. YOU SHOULD NOT TRY TO REPAIR THIS YOURSELF,YOU COULD ACTIVATE THE AIRBAG!!!!!

Posted on Nov 11, 2008

  • 142 Answers

SOURCE: airbag light stays on 2005 jeep liberty

It probably will cost a few bucks to get the code reset, but you don't need to go to the dealership, most shops with a good scanner equipped for air bag code reading will be able to diagnose and reset the light. The most probable reason for the code is the battery being dead for a while, there is a capacitor in the airbag circuit to make sure the airbag can go off in a collision even if the battery disconnects itself in the process. There is a slim chance it might be something else but either way the shop should be able to tell you what the problem is, and get it fixed... But, just for fun, before doing all this, i'd disconnect the battery for 30 minutes to an hour and reconnect it back, some systems do effectively reset themselves this way.

Posted on Jan 13, 2009

Brian032472
  • 150 Answers

SOURCE: 2003 Jeep Liberty heater fan problem

It is the blower motor resistor. Look under the passanger side dash and locate the fan housing (looks round and black in color. Then locate the resistor it will be in that housing usually withtwo ten millimeter nuts or two simple screws holding it in. unplug the harness to the resistor and remove the resistor. Part store price is approx. 50.00. Note: on aftermarket (not Jeep) resistor sometimes you have to modify the housing a little to get it in. Hope this helps.

Posted on Feb 01, 2009

alicantecoli
  • 22095 Answers

SOURCE: Flashing dashboard airbag light in 2003 Toyota Avalon

try wiggling wires under the front seats ,if that dont work then take the builb out

Posted on Mar 09, 2009

c17hydro
  • 2984 Answers

SOURCE: Identifying 2003 Jeep Liberty Automatic Transmission

What is your VIN number?

Posted on Mar 31, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Luz marcada con el numero cinco?


2003 Jeep Liberty- Reading Engine / Diagnostic Codes ...

? 1:13
https://www.youtube.com/watch?v=pGrPBBzp7wE
Jan 6, 2013 - Uploaded by DeathScouter
2003 Jeep Liberty- Reading Engine / Diagnostic Codes ..... error code will flash 2 times, brief pause, flash 1 time, pause, flash 5times, pause, ...

2005 Jeep Liberty possible cause of P0442 error. - YouTube

? 5:26
https://www.youtube.com/watch?v=2ba-gH0gadg
Dec 21, 2014 - Uploaded by TheBGravit
While replacing a bad fuel pump I believe I found the cause of a P0442 Error code. I was able to repair the ...

Jeep Liberty Questions - Cylinder Misfire code - CarGurus

www.cargurus.com > Questions > Jeep > Liberty

CarGurusMay 27, 2009 - My jeep Liberty 2009 does the same the Dashboard showed a code of cylinder .... i have a jeep liberty 2006 with the # 5 cylinder misfire. i replaced the sparks... I have a 2005 Jeep Liberty 6 cylinder, engine light came on scaned the ... 2002 jeep liberty camshaft posistion sensor error code p0340 5 answers.

Check Engine Light/Misfire Due to Intake Valve Locks ...

repairpal.com > Problems > Jeep > Liberty
Recently got a second hand 2005 Jeep Liberty Sport. Everything worked fine ... #5intake valve seat dropped and held open the intake valve. 2008 Jeep Liberty.

OBD-II Trouble Code: P0305 Cylinder 5 Five Misfire Detected

www.obd-codes.com/p0305


Dec 08, 2015 | 2005 Jeep Liberty

1 Answer

2003 jeep liberty bcm what does it control?


Check you alternator output . Low voltage will cause shifting problems

Jun 22, 2013 | 2003 Jeep Liberty

1 Answer

Check engine light stays on - 2003 jeep liberty sport - 87,000 miles


Dear Madam or Sir,

If the "Check Engine Light" comes up, the on board diagnosis system of your vehicle has detected an error with the petrol injection system, a faulty sensor, stuck servo motor etc. for example.

The light indicates the recognition and storage of an digital trouble code to the system´s memory to the driver. You should see a mechanic to check the ECU (engine control unit) for saved trouble codes.

Please don´t hesitate too long to prevent the engine from serious damage.


Kind regards from Germany

Auto Doc P.

Jun 26, 2010 | 2003 Jeep Liberty

1 Answer

Whats the oil capacity for a 2003 jeep liberty?


2003 JEEP LIBERTY 2.4L 4-cyl Engine Code [
Engine Oil Grade 1....API* SAE 5W-30 is preferred.
CAPACITIES:
Engine, with filter..........4.7 liters

2003 JEEP LIBERTY 3.7L 6-cyl Engine Code

Engine Oil Grade 1......API* SAE 5W-30 is preferred.

CAPACITIES:
Engine, with filter..........4.7 liters

Thank you for using fixya and good luck

May 31, 2010 | 2003 Jeep Liberty

1 Answer

Dashboard lights on 2002 Jeep Liberty Sport


Donna,

You can go to Auto Zone . They can scan the car for codes for free, and check the Alternator. I think with all the issue with the dash lights coming on, The codes should get a tech in the right direction. You could be right and the Alternator is the root cause of failure.

Good Luck

Aug 16, 2009 | 2002 Jeep Liberty

2 Answers

2003 3.7 Liberty check engine light for crank sensor


2003 3.7 Liberty check engine light for crank....what? sensor? You have scanned it?

Mar 06, 2009 | 2005 Jeep Liberty

3 Answers

2003 jeep liberty air bag light on is it easy to fix


The system needs to be checked for cades. Airbag codes are pulled out of the ECU with the use of a scanner tool. A good auto mechanic shop will have this or you can go to the dealer. YOU SHOULD NOT TRY TO REPAIR THIS YOURSELF,YOU COULD ACTIVATE THE AIRBAG!!!!!

Nov 11, 2008 | 2002 Jeep Liberty

1 Answer

2004 liberty


If your engine light came on, the engine module could have stored a code.
You need to have a scanner to check what code it is and that will point you toward the solution.
Possible causes could be (crank sensor, tps sensor or oxygen sensor).
Don't go replacing parts until you scan the vehicle for codes first.

Oct 03, 2008 | 2003 Jeep Liberty

Not finding what you are looking for?
2003 Jeep Liberty Logo

Related Topics:

759 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...