Question about 1993 Toyota 4Runner

1 Answer

What are they called and where do i get the flaps that protect the engine at front wheelwell

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.


    An expert that has over 500 points.

  • Expert
  • 148 Answers

Inner finder skirts

Posted on Jul 14, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2002 ford explorer front end flapping sound. Started truck this morning (in MI very cold right now) & was normal. About 5 minutes out, started a flapping sound that sounds like it's under the hood

Stop engine. Open hood and look at serpetine belt. Check fan shroud for flopping and being loose. Look under front of vehicle for plastic part hanging down and sometimes called an air deflector. Air deflectors seem to hit curb bumpers when you pull in and snow banks can tear them loose.

Jan 19, 2018 | Ford Cars & Trucks

1 Answer

Where is the Blower motor relay on a 2002 Ford Econoline E150, and how do you change it so both the front and rear blower motors work on all 3 speeds?

There would be two relay's , one for front an one for the back . And the relay would be for high speed only . And it just so happens there are two AUX blower motor relay's .
Auxiliary Blower Motor Relay C403
Left rear corner of vehicle, above wheelwell
Auxiliary High Blower Motor Relay C404
Left rear corner of vehicle, above wheelwell

Front blower motor relay - K73 top left , Six relay's at top left .

check it out here

Feb 17, 2017 | Ford Econoline Cars & Trucks

3 Answers

What is the name of the rubber protector or cardboard that is under the front engine part of the car, what is the purpose? it is torn and hanging near the ground.

If it's what I think you are talking about it's like a mud flap to protect the engine, starter, oil pan.
You can just rip it off you it's a problem.

Oct 28, 2015 | Cars & Trucks

1 Answer

Change starter in 1997 expidtion

This is a tight fit. Check for Service Bulletins called TSB's for your vehicle. I know the 1999 model had a connector issue at the starter, but do not know if the earlier units had same problem.

Some mechanics take off the passengers tire and work through the wheelwell. Having an extremely long socket extension allowing your rachet to be attached in front of the a/c compressor pulley will make removing the bolt nestled against the engine easier if you try leaving the tire on. Some use a combination of both methods.

Dec 10, 2013 | 1997 Ford Expedition

1 Answer

Where is the oil filter located on a 99 ford F150 triton v8?

the filter is located right above the front differential on drivers side on the engine if it is a 5.4. If it is a 4.6 then they put the filter in front of the drivers front wheelwell , adapter lines are ran from where the filter is on a 5.4
Good luck

Mar 23, 2011 | Ford F-150 Cars & Trucks

1 Answer


On 1996 Chrysler Truck Town & Country 2WD 3.8L MFI 6cyl the Engine Control Computer is located under hood, driver side, front side of strut tower, mounted on wheelwell.

Hope this help you (remember rated this asnwer).

Aug 08, 2010 | 1996 Chrysler Town & Country

1 Answer

How to replace the alternator.

Disconnect negative battery cable. Remove accessory
drive belt. Raise and support vehicle. Remove righ
front wheel. Remove right front wheelwell splash sh

Remove integrally-mounted generator shield. Disconn
ect field wires. Disconnect generator positive lead

Remove lower and upper generator mounting bolts. Re
move generator through wheelwell opening behind

Mar 21, 2010 | 2000 Saturn SL

1 Answer

Trying to find the fuel filter on my 1994 mazda 929

Under hood, passenger side, front engine area, rear of battery, above wheelwell, mounted in fuel line assembly

Feb 03, 2010 | 1994 Mazda 929

1 Answer

Fuel filter location on a 1996 caprice classic w/ 5.7 liter engine

Under vehicle, driver side, below seating area, front of rear wheelwell, mounted on chassis in fuel line.  Thank you for an honest rating and for using FixYa!

May 19, 2009 | 1996 Chevrolet Caprice Classic

1 Answer

2002 Camry LE Front Wheelwell splashguards.

This fender have screw slot in the inside the fender ,if you facing the problem you need to drill new set holes in the fender and secure plastic mud guard correctly if this is not done then you be facing the mud flap out its place and you need to replace it again ,so make sure you that you secure in place ....

Good luck...

Aug 24, 2008 | 2002 Toyota Camry

Not finding what you are looking for?
1993 Toyota 4Runner Logo

Related Topics:

30 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

79186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides