Question about 1997 Chevrolet Suburban

1 Answer

Spungy brake peddle and goes to the floor gm says nature of the beast stops ok but doesn't feel right

Posted by on

  • cjcole91 Jul 14, 2009

    thanks but tried already still goes almost to floor, What if i replace abs pump

  • stwrtanderso
    stwrtanderso Mar 16, 2013

    near gaurantee spongy brakes get your brake lines checked you,ve got water air or pooched lines get to the garage and get those lines and fluid checked before you hurt someone !!!!!!!!!!!!!

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 148 Answers

That is one of the wosrt ABS system it dose cause a soft peddle but you can sometimes adjust up the rear brakes to help this problem,also find a dirt road and slam on the brakes just enough to cause the ABS pump to kick on it will also give you a better peddle

Posted on Jul 13, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i bleed clutch on 2000 trans am ws6 ram air


I\'m assuming this is the one with the 5.7L LS1 V8. Ok, bleeding the clutch is real no different than bleeding your brakes. Locate our slave cylinder.(Not the reservoir) In most cases, it\'s best to start with a gravity bleeding. Make sure the reservoir is full, loosen the bleeder on the slave cylinder, until you have a steady stream coming out. Then tighten the bleeder, and check the peddle.SUCKAUTION**** MAKE SURE THE BLEEDER VALVE IS TIGHTENED AND CAP IS ON THE RESERVOIR BEFORE YOU TOUCH THE CLUTCH PEDDLE!!! AS MISSING THIS STEP WILL **** UP AIR INTO THE LINE.Step 2, have a friend sit inside the car, and continuously pump the clutch(like bleeding brakes) about 10 pumps should do it. Have friend hold the peddle to the floor and announce that it is to the floor. ***They must hold the peddle to the floor*****while they are holding the peddle, loosen the bleeder valve until fluid comes out. repeat process until no micro bubbles come out, just clean fluid. Finally, remember to top off your fluids after bleeding, as you will naturally loose some in the process. Hope this helps. ^^

Mar 27, 2013 | Cars & Trucks

1 Answer

My 1988 dodge Dakota 3.9 3 speed automatic 2 w Dr.idles rough and sometimes dies at a stop light and won't restart unless I put the gassed peddle to the floor.when it does finally start I have to keep...


Replace your hose going from intake to brake booster ( vacuum leak) check all other hoses also. Clean the throttle body. And a tune up probably wont hurt either.

Jun 09, 2017 | Cars & Trucks

1 Answer

How do you tell if a power brake booster is bad on a 1997 ford f150


Usually when the brake booster goes bad, when driving and trying to stop, the pedal is VERY hard to depress and the vehicle will not stop easily so don't drive fast, you will not be able to stop in short distances.

Mar 29, 2012 | 1997 Ford F150 Regular Cab

1 Answer

1994 gmc Sierra. Poor, soft, spongey peddle feel


well maybe the lines are not bleed right. did you bleed the master??

May 09, 2010 | 1999 Chevrolet Silverado 1500

1 Answer

94 s10 chevy 2wd brake pedal fades to floor before stoping


Might check around the big black round muffin shaped chamber adjacent to the master cylinder for a loose vacuum hose or crack therin; the hissing sound seems likely to be the air rushing in as you loose the vacuum that supplies the power to assist your braking effort (power brakes)---as this goes, so goes your peddle until it reaches the actual piston pushing the brake fluid (which should be firm like with non-power brakes).
...maybe have an assistant push on the peddle while you listen with a piece of hose or a stethescope to find the leak (or I suppose the power unit diaphragm could be shot/leaking--hence replacement), but since you said after bumpy road etc, one could hope for a simple dislodged vacuum hose or fixable crack.

Aug 08, 2009 | 1994 Chevrolet S-10

Not finding what you are looking for?
1997 Chevrolet Suburban Logo

Related Topics:

258 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...