Question about 1999 Ford Contour

Open Question

How to install windshield ford contour - 1999 Ford Contour

Posted by on

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Which fuse controls windshield wipers on 1996 Ford Contour

I just pulled out every fuse one by one to see if they were broken and I found one that was broken and replaced it and now my windshield wipers work.

Posted on Jan 10, 2009

akosomas
  • 4 Answers

SOURCE: Windshield wipers stopped half way.

there may be a wire disconnected or a fuse that has gone bad.
wiper motors are usually pretty expensive. you might be able to find it used but you also should check if they go bad a lot in that car so you dont get a used one just for it to go bad again so soon.

Posted on Jul 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Air Flow won't switch from Windshield to panel


it either a vacuum line the plug for it or a wire has broken off of one of these you can operate them manually
air-flow-switch-from-windshield-panel-soz3sbv2bqs4rejfawoh5mfu-1-0_0.jpg

air-flow-switch-from-windshield-panel-soz3sbv2bqs4rejfawoh5mfu-1-2.jpg

air-flow-switch-from-windshield-panel-soz3sbv2bqs4rejfawoh5mfu-1-5.jpg
look for these units on the heater case and make sure you try to operate them manually first if you disconnect the glove box door it might be easier to get to them

Mar 27, 2015 | 2000 Ford Contour

1 Answer

On my 1998 ford contour my windshield wipers wont work and a loud banging noise is happening even when they are off


It sounds as if the wiper linkage has come adrift, normally will require renewal of a link arm

Oct 20, 2012 | 1998 Ford Contour

2 Answers

On my 1998 ford contour le, my brake lights wont come on. The one on my rear windshield comes on but shouldn't i have some over by the tail lights too?


Yes, check the fuse and brake light relay in the engine compartment relay box. See my tip at http://www.fixya.com/TipsAndTricks/posttipandtrick.aspx?thid=6053280 and let me know if you have questions

Sep 18, 2010 | 1998 Ford Contour

1 Answer

Adding water to a 1996 ford contour?


Check the level of the coolant in the reservoir at least once a month. Be sure to read and understand precautions when servicing your vehiclein this chapter.If the engine coolant has not been checked for a long period of time, the engine coolant reservoir may eventually empty. If this occurs, add engine coolant to the coolant reservoir. For more information refer toAdding engine coolantin this chapter.
Automotive fluids are not interchangeable; do not use engine coolant, antifreeze or windshield washer fluid outside its specified function and vehicle location.

Check page 169 from Ford-Contour-Owners-Manual for other details.

Hope helps (remember comment andf rated this).

Jul 20, 2010 | 1996 Ford Contour

1 Answer

Windshield wipers and fluid not working in 1998 ford contour. replaced fuse before and they worked but now they wont and the fuse is fine. any suggestions please?


Sounds like the wiper motor is seizing up... it doubles and the washer pump ...
try to move them manually when you have them turned on...

Jul 15, 2010 | 1998 Ford Contour

1 Answer

I hav no wiper fluid coming out of the reservoir


Shure there is a fuse , and check you will.
Fill some more fluid.
Check nipple with a pin for bolckage. And hose if disconected.
Is it leaking somewhere else ?
Now check Amplifier module to motor and pump of windshield wiper assembly.
Next check actuation swich at cockpit.
heck voltage at pump at reservoir.
Direct conect live voltage to pump.
Finally replace pump.
Vitally

Sep 14, 2009 | 1998 Ford Contour

1 Answer

Windshield wipers stopped half way.


there may be a wire disconnected or a fuse that has gone bad.
wiper motors are usually pretty expensive. you might be able to find it used but you also should check if they go bad a lot in that car so you dont get a used one just for it to go bad again so soon.

Jul 15, 2009 | 2000 Ford Contour

1 Answer

Where is the fuse for the windshield wipers in a 2008 Ford Crown Victoria?


Had a response to where the fuse was located. Thank you.

Mar 02, 2009 | 1995 Ford Contour

1 Answer

Where is the fuse to the windshield wipers 1995 ford contour?


10 amp in interior fuse panel. And a main 30 Amp fuse feed in interior panel. see chart in owner guide or on fuse panel cover.

Feb 24, 2009 | 1995 Ford Contour

1 Answer

Which fuse controls windshield wipers on 1996 Ford Contour


I just pulled out every fuse one by one to see if they were broken and I found one that was broken and replaced it and now my windshield wipers work.

Jan 09, 2009 | 1996 Ford Contour

Not finding what you are looking for?
1999 Ford Contour Logo

Related Topics:

219 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5467 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...