Question about 1995 Chevrolet Camaro

3 Answers

Replaced water pump on 1994 3.4L camaro, put wires back on coil and can't get my car to start. it turns but wont start, what do i do? is the wire formation wrong???

Posted by on

  • Samuel Charles Spriggs May 11, 2010

    If the wires were not marked and put back in the same place, yes, this is a plug wire / firing order mix up. Charlie

  • Jeremy Huddleston May 11, 2010

    probably the firing order....did you take them off the plugs too or just the coil?

×

3 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 4 Answers

Had a similar problem - when I put the power steering pump back on the car, the 2 wires going from the coil to the main computer got wedged behind the power steering pump bracket and grounded out. Might be worth checking.

Posted on Feb 23, 2010

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Check your drive belt for the water pump

Posted on Oct 26, 2009

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Double check ignition wire placement. Make sure the coil didn't get disconnected somehow. Most likely you have the plug wires jacked up.

Posted on Aug 30, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

94 camaro wont start...no firefrom the coil has new icm , coil , fuel pump


Check the icm plug with a led testlight for pulse while the engine is cranking. Test the wire connector with the small wires going into the coil for pulse.The v8 has a opti-spark distributor behind the waterpump that is prone to failure. It has the pickup inside it that tells the icm when to spark. If no pulse at icm distributor is bad. If pulse at icm but not at coil, icm or wiring between icm and coil is bad.The coil also needs pos.+ power on 1 terminal to operate. Be SURE to check the security light on the dash. If VATS [vehicle anti theft system] fails its usually within the 2 wires going from the key chip in the ignition tumbler to the body control module. Mine were purple and tan.Trying to start it with the wrong key can put it in lockout mode also. There are bypass modules available online for vats problems or you can even install a resistor in the wire to bypass the keychip part and the door alarms still work.

Mar 27, 2014 | 1994 Chevrolet Camaro

1 Answer

Wont turn over.


Just as on inquire, is the ignition sensor located just below the water pump area, if it is that is what I would look at wire connections, frayed wires etc, that triger controls everything

Dec 03, 2013 | 2001 Chevrolet Camaro

1 Answer

I have a 84 camaro with hei distributor motor is a 69 camaro 350 i keep melting the wires on the coil put new coil in car runs good for an hour or so then gets warm and melts wires and stall also did new...


HEI distributor and burning coils,it in you connection first make sure you install primary and secondary prorperly as it comes out of the cap , and inside the cap wire from modules dont make contact if you are burning its from primary circuit, this is the (B+) or (battery most likely), your secondary is your tach and that need to switch from postitive to negative for it to create spark obvously if tach was grounded or applied power you wont start,but there are times the condensor in the distributor does stays fixed and shorts out the coil (replace that condensor its for suppression) when the condensor is replaced run a fused direct wire at B+ (from ignition) run the vehicle and monitor the tach wire and check to see if that get hot

May 08, 2011 | 1984 Chevrolet Camaro

1 Answer

Car cranks but wont start


if no codes or check engine light try spraying with starter fluid if starts or ignites u have spark /no fuel check fuses and relay for fuel pump -check fuel filter fuel pump fix or replace parts -no spark but have fuel check distributor wires and plugs coil

Oct 14, 2009 | 1998 Chevrolet Camaro

2 Answers

Car wont start


First, look for broken or loose wires in the ignition circuit, and the coil wires. Then try fuel filter. Then, ignition module, coil, and timing. It could also be dirty or clogged injectors.

Jun 11, 2009 | 2004 Oldsmobile Alero

2 Answers

02 camaro wont start fuel pump relay or fuel pump ? How to tell ? The car started right up then died & wont start ! I dont hear the noise from fuel pump when I turn key !!


Take the fuel line off before the filter and turn the key on and see if you get any fuel out of the line. If you don't get any fuel unplug the wire connector to the fuel pump turn the key on and see if you get a hot wire going to the pump. if you get a hot wire then it is your pump. If you do not get any hot wire then it should be the relay.

Mar 21, 2009 | 1993 Chevrolet Camaro

2 Answers

1996 Camaro RS suddenly wont start - anti theft problem?


You can start it by putting into program mode...try to start, then turn it to off..,,then turn it to on (not start)..leave it on for 15 min...turn it to off for 2 min..and start..

This will reset the signal from the bcm to the pcm of the car.

you most like ly have a problem in the start switch key reader...It has to be replaced as a unit

Or it could be your bcm or pcm...very very expensive... try this first... If it does not work off to the dealership..don't even try to give this to a garage to fix. Gm has the software to reflash your computer.

Aug 03, 2008 | 1996 Chevrolet Camaro

Not finding what you are looking for?
1995 Chevrolet Camaro Logo

269 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...