Question about 2007 Chrysler Pacifica FWD New Cars

1 Answer

I have a 2007 Chrysler pacifica the remote only opens the driver door. How do I get it to open all the side doors

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 431 Answers

Hi I am Vortash it is possibly a low battery in the key fob and you may need to go to a dealer to get it replaced ?.. however it sounds a little more like the fault may be in the reciever rathere than the key fob as it is not actuating all the doors .. hope this helps regards Vortash

Posted on Jul 13, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Doors not opening even if they are unlocked


My 2009 Sebring does the same thing occasionally but only the drivers door gets stuck (dead locked - even though the locks appear to pop up).
The solution I have found once this happens is:
1) The car needs to be driven (crawl in thru the passenger door) -even just a short distance
2) Engine shut off & doors locked with remote (after you've exited from the passenger door of course)
3) Leave turned off for 10 minutes
4) Doors will now open when unlocked with the remote

Mar 14, 2014 | 2007 Chrysler Sebring Sedan

1 Answer

Hi my door driver side is no open by remote, just close by remote!!! i dont no what is the problem!! help pls!!!!


It either needs the door latch replaced for that door, or there are broken wires in the door jam harness.

Jan 16, 2014 | Cars & Trucks

2 Answers

Location of tail gate alarm on 2004 Chrysler Pacifica


you may have a bad switch which is located on the latch asm

Sep 03, 2012 | 2004 Chrysler Pacifica

1 Answer

Where are my fuse boxes located in my 2007 chrysler pacifica


I think that they are under the hood somewhere. I know that in some cars they put them on the left side of the center console. To look for these just open the driver door and there should be a place that pops out on the left. Hope this helps

Apr 16, 2012 | 2007 Chrysler Pacifica FWD New Cars

1 Answer

How to program 2007 chrysler Pacifica to open garage door opener


GOTO Homelink.com


They make the system - you can download step by step instructions.


Follow carefully if you miss anything you need to start over.


Hope this helps.

Feb 20, 2011 | 2005 Chrysler Pacifica

2 Answers

Program instruction garage door opener in 2005 chrysler pacifica


if your garage motor have rolling codes you need to put your car inside garage near the motor leave ignition on go to the motor locate learn button press it then quickly go to the car and press and hold one of the buttons for approximately 30 sec or until it start blinking rapidly, if you have a regular motor take one hand held opener go inside car ignition on same time press open button on handheld remote and on the car button 30 sec and it should be programmed.

Apr 24, 2009 | 2005 Chrysler Pacifica

2 Answers

2005 Chrysler Pacifica passenger doors have no power


If your alarm went off, it could be that someone had tried to break into your car. They most likely may have cut some of the wires inside your door with what ever device they may have been using. Look for evidence between the bottom of the windows and doors where the problem is. If not, then it is possible that your automatic window assemblies are malfunctioning. Do you hear the motors run on the windows when you go up or down with the switch? I also have a Pacifica, 2005, however no window problems yet.

Good Luck,

Ray

Apr 21, 2009 | 2005 Chrysler Pacifica

2 Answers

Universal garage opener


The solution is in the owners manual.If you want to program the "homelink transmitter" in your car,you will need a remote unit for your garage door opener to do this.It is fairly easy and straightforward.I programmed my 07 Pac and it works great.Good luck!

Mar 08, 2009 | 2005 Chrysler Pacifica

Not finding what you are looking for?
2007 Chrysler Pacifica FWD New Cars Logo

319 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...