Whether it's an engine oil pan (called the 'sump'' in the UK) or a transmission oil pan the principle is the same on all vehicles.
1. Drain the oil
2. Remove the bolts holding the sump/pan in place:
The oil drain plug, though depending on your vehicle it may look different:
New gasket held in place with sealant
Use a blunt screwdriver -if needed - and prise the oil pan free. remove all traces of the old gasket from the mating surfaces.
Use a smear of sealant to hold the new gasket in the correct position on the pan - this will hold it in place when you refit the pan.
Push the pan into position and put in a front bolt finger-tight. Then put in a rear bolt finger-tight.
Putting in the bolts finger-tight allows you to gently 'move' the pan if needed to put the bolts in one at a time.
When all bolts are in, tighten them with a wrench/socket. Then check them all again for tightness.
It isn't actually a big job .. more 'messy' because of the oil.
Carl, since you've not told us what make/model/year/engine you're working on, all I can offer you is pretty generic advice:
1. Remove oil pan.
2. Clean old gasket from engine block and old pan.
3. Apply gasket sealing compound to oil pan.
4. Set gasket on oil pan
5. Apply gasket sealing compound to top of gasket
5. Attach oil pan to engine.
http://schematicsdiagram.blogspot.com/2011/12/how-to-replace-oil-pan-on-2008-honda.html
-----------
How to replace Oil Pressure Sensor on 2008
Honda Odyssey?
http://schematicsdiagram.blogspot.com/2011/12/how-to-replace-oil-pressure-sensor-on.html
------------
2004 Chevrolet Express Van: Oil pressure
sending unit replacing?
http://whoisbyme.blogspot.in/2012/06/2004-chevrolet-express-van-oil-pressure.html
-------------
HOW TO REPLACE AN OIL PUMP
http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-oil-pump.html
-------------
HOW TO CHANGE ENGINE OIL AND FILTER
http://schematicsdiagram.blogspot.com/2011/07/how-to-change-engine-oil-and-filter.html
--------------
HOW TO REPLACE AN OIL PRESSURE SWITCH (SENSOR)
http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-oil-pressure-switch.html
-------------
How to
Check Differential Oil Leaks and Replace Oil
http://schematicsdiagram.blogspot.com/2011/07/how-to-check-differential-oil-leaks-and.html
-----------
HOW TO PERFORM A BASIC ENGINE TUNE UP-OIL CHANGE
http://schematicsdiagram.blogspot.com/2011/08/how-to-perform-basic-engine-tune-up-oil.html
----------
HOW
TO RESET OIL CHANGE INDICATOR?
http://whoisbyme.blogspot.in/2012/07/how-to-reset-oil-change-indicator.html
------------
These details will help.
Thanks.
484 views
Usually answered in minutes!
×