Question about Chrysler Town & Country

1 Answer

Car vibrates at slow speed, veering to the right,steering wheel vibrates; vibration less at higher speeds; within last two weeks couple of times steering hard, revved up in neutral it comes back to easy steering

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 57 Answers

Check tyres for wear-wheel balance needed if visibly ok-have a wheel alignment after a tyre rotation-best even tyres to be put on fronts-they will carry out a safety check all suspension and steering before doing the wheel alignment

Posted on Jul 13, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What causes my 2-wheel drive ranger to vibrate hard when I turn the steering wheel at low speeds only, like pulling out of garage? also does it in reverse. makes a noise near the rear when it is vibra


i would say it is a solenoid or air in the power steering lines but you would have to put a obd2 scanner and see what it says.
if i remember correct bleeding is as simple as removing the power steering cap and turning steering all the way left hold for 5 seconds then right and hold but you will need to look at oil in reservoir and see if it is bubbling while turning and holding. you will need a helper and if it is do this for 5-10 minutes.

Oct 10, 2014 | 2000 Ford Ranger SuperCab

1 Answer

Vibration on 2004 Cadillac Deville


If a hub bearing was bad, it almost always would make noise, more so when changing lanes at higher speed. Outer CV joints make a loud low pitched rattle when turning (corners). Inner CV joints raise hell at high speed- bad shake! Sway links affect cornering and clunk when hitting rough patches of road surface.
Is the vibration worse at 65 than at 50? If so, you are dealing with a wheel balance situation. Find an old time front end shop that will check the balance on the vehicle. You will have to turn off the traction control to do this or use an on-the-car wheel balancer.
If you feel it at some low speeds at it comes back at other higher speeds, then you are dealing with tire roundness. Possible more than 1. More common than we would like.

Jul 17, 2017 | 2004 Cadillac Deville

1 Answer

1999 Wrangler - Wobble/Vibration


this problem could be a worn or loose wheel bearing or a worn or broken shock or a worn tie rod inner or outer.

Nov 21, 2011 | 1999 Jeep Wrangler

2 Answers

I have a 2003 Spyder, automatic with a 4 cyl engine. The steering wheel shakes at low speeds--below 30 mph, like a bent wheel, but it does not do it all the time or at higher speeds. Also, during moderate...


check your upper control arms, does it happen when you step on the brakes or just when driving, you might need a balance of all your wheels or the tires you have could be bad.

Oct 22, 2009 | 2003 Mitsubishi Eclipse Spyder

2 Answers

Thumping coming from front end all speeds.


IF IT ONLY THUMPS WHEN YOUR CAR IS MOVING YOU COULD BE WRITE. PAY ATTENTION TO THE THUMPING CLOSLEY, DO YOU FEEL A VIBRATION IN THE STEERING WHEEL, IF SO THE PROBLEM IS IN THE FRONT END. IF YOU FEEL A VIBRATION IN THE DRIVERS SEAT THE PROBLEM IS IH THE REAR END. YES THE VIBRATION FROM THE FRONT STEERING AND THE DRIVERS SEAT IS A WAY TO TELL WHERE THE PROBLEM IS

Aug 10, 2009 | 1994 Volkswagen Jetta

4 Answers

Steering wheel vibrates badly at certain speeds on highway.


I would put money on it that you have a bad belt in a tire...

Aug 06, 2008 | 2001 Ford Escort ZX2

2 Answers

Vibration in steering column


if your vibration comes and goes with different speeds, most likely problem is balance in tires/wheels. a bent wheel often vibrates more with higher speeds. if the vibration is stong in the steering wheel, the problem is normally in the front end, if you feel in more in the seat or body of the car then look to the rear end.

May 14, 2008 | 2005 Buick Terraza

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

801 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...