Question about GMC Jimmy

1 Answer

The fan was intermittent for several months then off far more than on and not that the temp is 100F outdoors, the fan does not work at all. there is power at the blower motor but, with the connector unplugged, there is 12v on both sides of the connector. The blower makes no noise (as if attempting to run) help please thanks

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,124 Answers

I would say the fan motor is bad..

Posted on Jul 13, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is it normal for the gas to get real hot in the tank


first off your fuel should not be heating up this sounds like you have an exhaust issue. either either a pipe coming in contact with the tank or an exhaust leak blowing on it. it is also possible the exhaust system was improperly rerouted casing the issue. As for the temp of 100F, that should not cause any issues, the fuel in the tank shouldn\'t be a problem until well over 120 degrees as the vehicles are designed to operate over that temp. and as far as fuel blowing out of the filler tube, there again, it sounds like it was improperly altered. the only way this could happen is if the tank became heavily pressurized (as if it was heated by exhaust) and the filler tube was submerged in fuel. However the filler should never be in this condition as it is connected at the TOP of the tank where it can not be submerged as it does not even ENTER the tank, it simply connects to a flange that is on the top of the tank. Ive literally replaced DOZENS of tanks over the decades, they are ALL made this way, it is a safety design requirement.

Sep 05, 2014 | Nissan Maxima Cars & Trucks

2 Answers

P0300 cylinder random


A smog check/diagnostic at a reputable shop should reveal any catalytic converter problems. As far as random cylinder firing, there are several things which might present problems. I will list a few for you to consider: 1. Engines with higher mileage often have carbon deposits built up on the piston,valves, cylinder head,etc. When hot from running, these deposits can result in unexpected detonations of combustion chamber. 2. Condition of spark plug wires: old wires may "leak" meaning allowing current through the insulator. Also, sometimes wires run parallel to each other for a distance can create inductive firing out of order. 3. Spark plugs with deposits can cause detonation out of sequence. 4. Valve lash out of specification or worn cam can allow hot gases to detonate chambers. Sticky valves/guides may not be seating (closing) properly.

Nov 05, 2013 | 1999 Toyota RAV4

1 Answer

Radiator overheated and busted open, we bought a new radiator and the fan isn't working , also put a new relay on, and the fan isn't working. What next?


Did you check the temp sending unit? That tells the computer what the temp is and the computer then triggers the relay. Also, hot wire the fan motor and make sure it runs when it has power.
As far as the radiator "busting open" if it actually did that and didn't just develop a leak, it may indicate a head gasket failure pressurizing the radiator far more than it's normal capacity.

Jun 06, 2010 | 2000 Jeep Grand Cherokee

1 Answer

Starter turns but no ignition, PK3 M security


I have an 03 montana intermittant no start, security light flashes at the time of no start. Under the steering colom is a plug that comes fron the ignition with 4 wires pink , orng , blk, ppl. follow the wires and there is a plug. Try unpluging it then plug back in and try to start vehicle. If it starts then what i have done with it was wire in a relay that cuts power on ignition off and will power the module up on ignition.

blk to # 85 on relay, cut orng and attach one to # 30, the other to # 87, then attach pink to # 86. I have this working for 3 months so far no more intermittant start.

May 10, 2010 | 2002 Pontiac Grand Prix

2 Answers

Radiator fan cycles continously. Fan radomely comes on and off frequently and has consistently gotten worse. Because of intermittent problem, Mazda was unable to diagnose problem. Any advice would be...


First, intermittent problems are the worst! I would look for a bad or loose connection. Does the fan ever run consistently? If you turn on A/C most cars will run fans continuously, if yours works ok on this setting then problem is isolated to temp control (fans ok, wiring ok, relay ok) The temp switch would be probably be faulty (or connections). If your fans cycle even on A/C setting then you are looking at a complete electrical inspection. Switches, wiring, fuses, connections, relays, fans...everything! Hope this helps and good luck!

Mar 17, 2010 | 2006 Mazda MPV

1 Answer

Electrical prob: passenger mirror, drivers window and cabin fan


there is a very good chance that you have a very poor earth (ground) connection. check all the the earth wires make sure that they are clean and tight even the ones under the dash you might have to look at a user manual to check where all of the earths are some are hidden away behind carpets and plastic trims all of these need checking remove them rub with abrasive cloth and refit making sure they are tight.

hope you find this helpful Regards JR

May 31, 2009 | 1999 Chevrolet Venture

1 Answer

Cooling fan won't shut off


100% SURE YOU NEED FAN CONTROL MODULE BEHIND RIGHT HEADLIGHT AND GRILL. NOT HARD TO CHANGE BUT DEALER SAYS IT IS. JUST CHANGED ONE A MONTH AGO AND IS THE 4TH ONE THIS YEAR I DID

Mar 29, 2009 | 2000 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

139 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...