Question about 2003 Chevrolet Monte Carlo
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
you have to take off the steering wheel.if you dont have the right tools to do so i would not attempt it.the turn signal switch has to be moved it just pulls over the end of the column.then there is a torx head screw at about 1 oclock in the column that has to be removed.and the ign.just pulls out.the dimmer switch is kinda tricky.a locksmith usually dont charge to much to do this job.it would probably cost you more to buy the tools you need to do it yourself
Posted on Jan 22, 2009
Nope, it has two bolts one towards the front and one at the back underneath. Be careful of the one in the back as the nut is tricky to get on. You don't need to remove the bracket.
Posted on Feb 18, 2009
To remove the oil pan on any vehicle, first remove anything obviously in your way...starter, exhaust pipe etc. Then disconnect the engine mounts and raise engine to gain sufficient clearance between frame and pan. You cannot support the engine from under the pan so either use a fixture above the engine or put blocks between mounts and engine to support it. After all rail bolts have been removed, remember that the oil pump pickup will interfere with removal somewhat but pan can be maneuvered around it. Anything preventing you from getting the pan out will then need to be removed or moved as they are identified. Be careful when raising the engine that you do not break anything above it as it comes up.
Posted on Jun 09, 2009
The ck engine light should not be ignored, what sensor was shown to be bad ? Have it scanned again and replace the sensor that is bad if it still runs rough you might want to consider a tune up. Plugs, wires, fuel and air filter's and clean the throttle body with some gumout. It could also be the IAC motor Idle Air Control. Good Luck
Posted on Jun 23, 2009
you can either remove the steering pump to gain access,if there is no holes in PS pump pulley,you can rent a pulley puller....can be a ***** to get in and use them though....I will drill a hole in it for next time whenever I replace a pump on cars without ....
Posted on Aug 09, 2009
Tips for a great answer:
Mar 06, 2015 | 2003 Chevrolet Monte Carlo
Dec 31, 2012 | 2003 Chevrolet Monte Carlo
Dec 31, 2010 | 2003 Chevrolet Monte Carlo
Aug 02, 2010 | 2003 Chevrolet Monte Carlo
Mar 06, 2010 | 2003 Chevrolet Monte Carlo
Feb 13, 2010 | 2002 Chevrolet Monte Carlo
Aug 09, 2009 | 2004 Chevrolet Monte Carlo
Dec 24, 2008 | 2003 Chevrolet Monte Carlo
152 people viewed this question
Usually answered in minutes!