SOURCE: 1998 Kia sportage 4wd 2.0 dohc, is this non interference engine
NO NEED TO REPLACE CAMS OF SHAFTS, AS LONG AS VEHICLE WAS WELL MAINTAINED, MIGHT HAVE TO REPLACE BELT TENSIONER.
SOURCE: can't find the spark plugs on a 2004 kia spectra gs
If you have the 4 cylinder (which is sounds like you do), you have 2 wires and 4 plugs. The coil has an extender that goes deep into the cylinder, the wire is attached to the side to fire the 2nd cylinder. This is what is known as the waste-spark system.
To change the plugs, remove the cover like you did previously. Next, separate the wire from the coil. Then lift the coil straight-up out of the engine... you will see one plug hidden under there. Lastly, remove the wire and you will see the other plug. Since you have two coils, you will have two hidden plugs, the other two are under the wires.
Since it is a deep drop to the plug hole, replace the plugs by putting a hose over the white part of the plug and gently drop them down into the plug hole. You can also tighten the plugs since the hose will probably have a snug fit.
Since you have aluminum heads, be sure to dab some oil from the dipstick onto the threads of the spark plugs... this will prevent them from sticking inside the head the next time you remove them which saves the threads from being torn out.
I hope this helps.
SOURCE: How do you replace a Drivers side headlight bulb 2006 kia spectra
Helps to remove the battery, but small ahbds can do it.
Directly behind the lens is a big round cap ... twist it off. The bulb is held in place with a spring that locks in to a notch in the holder. When handling the new bulb, don't touch the glass. The oil from your skin will cause it to shatter when turned on.
SOURCE: kia sephia, 1.8l 16v dohc, interference engine or
yes its an interference engine i know for sure. side note most if not all dohc engines are interference.
180 views
Usually answered in minutes!
×