Question about 1995 Chevrolet Blazer

1 Answer

Need to replace the oil lines on 95 chev blazer is it hard to do

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Chevrolet Master
  • 3,854 Answers

It's harder then it seams, you have to disconnect the engine mount on the drivers side to get enough room to remove and replace the old oil lines. Other then the engine needing to be raised a bit, it's simple. Good luck and hope this helps, it takes about 3 to 4 hour to do this job. 

Posted on Jul 13, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Sensor light on a 95 chev blazer now on after heater core replacement


You have something disconnected somewhere after the dash was removed to replace the heater matrix ,the ABS computer is the only one which will reprogramme itself without any software but somewhere a multiplug is adrift iam sure

Oct 20, 2012 | 1995 Chevrolet Blazer

1 Answer

95 chev blazer check engine light won't come on


If the truck runs, I would say its a bulb.
If the truck won't start, look at the fuse for the ECM.

Jul 07, 2012 | Cars & Trucks

1 Answer

95 blazer remote oil filter line broke engine died is there a low oil shut off sencor to save engine


Hi, after starting, the fuel pump power runs thru the oil pressure switch. The switch saved your engine.

jturcotte_1125.gif

Feb 27, 2011 | 1995 Chevrolet Blazer

1 Answer

1998 chev blazer 4x4 4.3L vortec do i need to pull the engine to replace the transmission oil cooler lines?


Are you serious?
The answer is no. Please look things over before you ask a question.
The transmission cooler lines, last the life of the vehicle
What is the problem?
There is no parts avail for that. You have to make your own repairs.

Sep 19, 2010 | 1998 Chevrolet Blazer

1 Answer

95 S10 blazer 4.3 vortec skipping code po172 and po300 possible solutions


P0172 system too rich bank 1. P0300 random multiple misfire. All are a common symptom of either bad fuel pressure regulator or leaking injector. Need to pull off intake plenum (upper) You should visibly see a clean side or part of intake manifold (lack of carbon buildup) Reconnect fuel lines. Energize fuel pump (turn on key to run) Most likely you will see fuel dripping out of rear (fuel pressure regulator) or nylon lines to each cylinder (fuel injectors). Once you see which is leaking will need to replace. Once they are repaired will need to clean or replace spark plugs & change oil & filter.

Jun 26, 2010 | 1995 Chevrolet Blazer

1 Answer

Vacume line system where can i get a diagram for a 1991 chev s-10 blazer


there hard to find maybe dealership or one of the old chilton hard back books

Feb 18, 2010 | 1991 Chevrolet S-10 Blazer

1 Answer

My 95 chev blazer was kinda lurching while driving and now it's acting like it's starving for fuel. It's fuel injected, but I had to pump it. Is there and where is it a fuel filter outside of the tank


I would replace the fuel pump,yes there is a fuel filter,if it is stopped up,replace it,and then in about a week,the fuel pump will go out,it always does,sorry.

Jan 08, 2010 | 1995 Chevrolet Blazer

1 Answer

Chevy Blazer 1992 Oil Pump Change


you have to drop the oil pan to get to it...once the oil pan is off there are 2 bolts that holdthe pump in place,,,you will also need a new screen for the new pump.

Jan 03, 2009 | 1999 Chevrolet Blazer

1 Answer

Oil change light needs to be reset


turn the ignition to on without starting and press the gas pedal 3 times within 5 seconds to reset

Nov 12, 2008 | 1999 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

126 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...