Question about 2002 Isuzu Rodeo

2 Answers

2002 isuzu rodeo won't start

2002 isuzu rodeo, won't crank, push starts and runs fine. took out starter and had it tested at store, they said it was good. Tried test light under the hood and there was no problem I could find. Someone suggested it could be the clutch pedal ignition lock switch. Is it also called neutral safety switch and other names? Where is this located and is it easy to change?

Posted by on

  • father081104 Jul 15, 2009

    Thank you very much, it appears the clutch switch is the problem, when it was bypassed my truck started right up! Have the part on order...thanks so much for the help.

×

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 120 Answers

Good day;
the clutch switch is located on the clutch pedal support, if you put your hand on the clutch pedal run your hand up and the switch will be at the top. now if you are going to replace this switch I would try to adjust the switch first the amount of time it takes and this would confirm that it's the switch. ensure clutch pedal is fully returned, disconnect the electrical connector from the switch. loosen lock nut and tighten clutch switch by hand until switch is firmly against clutch lever. back the switch out 1/2 turn, the switch plunger should extend .02-.06" (.5-1.5 mm).
hope this helps

Cheers

Posted on Jul 13, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 108 Answers

Look under the dash at the clutch pedal. Should be a switch or a button hidden under there near the top of the pedal. Pull the connector off and put a large paper clip in it, or a short piece of wire, and try the starter. If it doesn't work then check the starter fuse and relay. Just swap the starter relay out with something that you know works like the AC or Fuel pump and see if it starts. If all else fails then it could be the ignition switch itself.

Posted on Jul 13, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 isuzu rodeo


Loose or corroded battery cables. Also possibly a bad starter solenoid or starter. Clean and tighten battery terminals. If it still does this, remove the starter and have it tested at any auto parts store.

Hope that helps.......

Jun 24, 2008 | 2001 Isuzu Rodeo

1 Answer

Have a 2003 Isuzu rodeo 6 clyinder 4wheel . Starter turns over a little longer before cranking. Done tune up, changed out fuel regulator but still dose the same ,what is my problem . t


a little longer before cranking.

what does that mean?

dont crank,
cranks slow.
cranks (Fast) called normal.
cranks fast starts, then stalls.
cranks fast, starts easy, starts, runs and stays running, normal
at what point does it fail, and how exactly.

we can't hear it, or watch you, so...................................

Dec 13, 2015 | 2003 Isuzu Rodeo

3 Answers

2002 Isuzu rodeo stop while driving wont start


Need more information. Could be fuel pump, fuel filter, crank sensor, cam sensor. Starter??

Oct 16, 2014 | 2002 Isuzu Rodeo

3 Answers

1995 Isuzu Rodeo won't start all of a sudden.


Check connection battery,could be starter.

Jun 05, 2013 | Cars & Trucks

1 Answer

My 96 Isuzu rodeo won't start and key is stuck in ignition


either that or the ignition switch itself is binding up

Oct 27, 2009 | 1996 Isuzu Rodeo

1 Answer

My 1999 isuzu rodeo wont start.


check all your connections to your alternator,starter and your battery But you you are hearing the starter "click" but not engage..try tapping on the starter with a hammer if it is easy to get to..this some and sometimes does work..but your starter solenoid can be bad..the starter can be bad..igntion module a number of possibilities..goto your local parts store or public library and purchase a repair manual or check one out at the library

Jul 30, 2009 | 1998 Isuzu Rodeo

2 Answers

Won't crank, will push start and runs fine.


make shure your baterie haves abaut 13 amps
then check your starter solenoid make shure that curent is geting there wen you turn the key

Jul 13, 2009 | 2002 Isuzu Rodeo

Not finding what you are looking for?
Cars & Trucks Logo

1,306 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...