95 Lexus es 300 replacing cv axel and oil seal in transmission I need to no name of part that goes behind the oil seal it's broke in pieces can't find a breakdown on seals bushings any help

SOURCE: left axle seal leaks because

there are two different axles for the vehichle you described ifu replaced axle u probably need other part # axle

SOURCE: RADIATOR REPLACEMENT

• At the time of installation, please refer to the following items.
• Start the engine, and check for coolant and A/T fluid leaks.
• Check the A/T fluid level.

1. Drain engine coolant.
2. Canada: Disconnect relay block (for daytime running light system) from battery hold-down clamp.
3. Disconnect upper radiator hose from radiator.
4. Disconnect lower radiator hose from water inlet pipe.
5. Disconnect A/T oil cooler hoses from oil cooler pipes.
6. Disconnect No.1 and No.2 cooling fan connectors.
7. Disconnect No.1 Engine Coolant Temperature (ECT) switch wire connector.
   
   
8. Remove radiator and cooling fans assembly.

1. Remove the 2 bolts and 2 upper supports. Torque: 12.8 Nm (9 ft. lbs.)
2. Lift out the radiator, and remove the radiator and cooling fans assembly.
3. Remove the 2 lower supports.
   

1. Remove A/T Oil cooler hoses from radiator.
2. Remove lower radiator hose from radiator.
   
3. Remove No.1 ECT switch.
   
   
4. Remove No.1 cooling fan from radiator. Remove the 2 bolts and cooling fan. Torque: 5.0 Nm (44 inch lbs.)
5. Remove No.2 cooling fan from radiator. Remove the 3 bolts and cooling fan. Torque: 5.0 Nm (44 inch lbs.)

SOURCE: ES 300 servicing: Lexus Dealer vs. Toyota Dealer

no there is not really a downside dealers are good it doesn't really matter who does it but lexus is more familiar with lexus vehicles than toyota because they specialize in it but something like that is simple .

SOURCE: check engine light on 95 lexus es 300

i have a es300 95 check engine light on sometimes it blinks car putts in park,in drive,when ac on the putts worst

SOURCE: Rear Axel Seal Leaking, How do I pull the axel to repair?

You will need to remove the differential rear cover,drain fluid, remove wheel, brake drum, (rotor) . Unbolt center diff. pin, carefully remove (don't loose shims) push axle in remove lock keeper, then slide out axle, replace seal, put some grease on it, slide axle in reverse all to install.