Question about 2005 Dodge Dakota

Open Question

Removing the back headrests on a Dodge Dakota 2006 truck

I cannot remove the back headrests on my Dodge Dakota 2006 truck. I have put a paper clip in their and pulled the small clip out but the seats will still not budge.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
shanat
  • 359 Answers

SOURCE: HEADREST REMOVAL

check for a release button between top of seat and the head rest

Posted on May 24, 2008

Ad
  • 50 Answers

SOURCE: help with changing fron brakes on a 2006 dodge ram truck

After you have removed the caliper from the caliper mounting bracket, remove the pads and guides.  Make sure you have fully depressed the caliper's piston fully then you can start by putting the little guides back in then reloading the new pads back in the caliper.  Be sure to use some caliper grease on the caliper mounting bolts (the bolts that hold the caliper in place).  If you don't use grease on these mounting bolts, your caliper won't slide right and you can have uneven wear on your pads.  This could easily cause overheating.  Once you place the caliper back in the mounting bracket and tighten the caliper mounting bolts back down tight you are all done.  Put your wheel back on and tighten the lug nuts and you're done!
MAKE SURE WHEN YOU FIRST START THE TRUCK FOR A TEST DRIVE AFTER INSTALLING THE BRAKES, YOU NEED TO PUMP THE BRAKES BACK UP!!!!  IF YOU DON'T YOU WILL START DRIVING AND HAVE NO BRAKES!!!  PUMP YOUR BRAKES ABOUT 10-15 TIMES FULLY OR UNTIL THE BRAKE PETAL SEEMS FIRM.  ALLOW THE BRAKE PETAL TO COME ALL THE WAY BACK UP BEFORE PUMPING THEM AGAIN.

Posted on Feb 02, 2009

  • 66 Answers

SOURCE: back drum brakes

Remove the rubber plug at the back of the backing plate. Take a brake adjusting tool or screw driver through the hole and turn(pry) the brake adjuster to back off the brake shoes. There is a ridge worn in to the brake drum and that is keeping the brake drum on, even if you can wiggle it.

Posted on May 21, 2009

  • 166 Answers

SOURCE: how to remove front headresr

pull up

Posted on Jun 02, 2009

c1apton15
  • 3400 Answers

SOURCE: 2001 dodge dakota v6 removing truck bed to replace

Maybe this will help - http://www.dodgedakotas.com/boards/v8/11354.html

Posted on Apr 07, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How to remove the rear headrests on a 2015 BMW 428i convertible?


Rear Headrest removal on Convertible - Bimmerforums

www.bimmerforums.com/.../showthread.php?...Rear-Headrest-removal...
Sep 6, 2008 - So I've searched and I've tried to yank the rear headrests out like what I'm reading and I ... Bimmerforums - The Ultimate BMW Forum - Powered by vBulletin... 3 series & 4 Series (E21, E30, E36, E46, E9x, F30, F32, F33, F44).

convertible - possible to remove rear headrests? (car seat issue ...

www.bimmerfest.com > ... > E90/E91/E92/E93 (2006 - 2013)

Mar 10, 2012 - 25 posts - ‎14 authors
Unfortunately the rear headrests or head restraint gets in the way and ... So as a temporary measure, I'm wondering if it's possible to actually remove the car's rear head restraints? ... HR&G Full Review: 2014 F33 428i M-Sport Convertible (my side .....2001-2015 performanceIX, Inc. All Rights Reserved . 335i convert booster seat - suggestions?
6 posts
Mar 17, 2008
Removing Rear Seats From E36 Convertible, Help!
17 posts
Feb 10, 2006
More results from www.bimmerfest.com

How To Remove Back Headrest BMW E36 - YouTube



Jan 16, 2016 | BMW Cars & Trucks

Tip

Bothersome Headrest Fix


I just got a 2008 Cobalt and I didn't like the way the headrest tilted my head forward. I found that I could remove the headrest and turn it around. It is much more comfortable that way.

The first step is to lift the headrest to the highest height.
Then insert a paper clip in the little hole on the side of the headrest slide. (You may have to press the realease ad lift on the other side first)
The headrest will then lift out completely.
Flip it around and put it back in.

You will need the paper clip to adjust the height, but this seems like a one time adjustment.

on Jun 20, 2008 | 2008 Chevrolet Cobalt

1 Answer

Remove headrests


There is normally a push button for adjusting the headrest height. This is the same button that you use to get it off. Sometimes they pull instead of push but you have to do it while pulling the headrest.

Apr 09, 2014 | 2010 Dodge Challenger

2 Answers

How to remove the headrests to put seat covers on for a 1989 crown victoria?


90% of head rests just pull out. the others will have a button where the headrest goes into the seat. If yours doesn't have the button, then push the headrest down and **** it up with some force and it will come out. Just be carefull you don't hit yourself in the face with it. Been there done that

Feb 08, 2011 | 1996 Ford Crown Victoria

1 Answer

How do i remove the headrest 2006 ford f 150


You just have to push the button on the side of one of the bars that connects to the headrest and lift up. On some vehicles you have to insert a paper clip into a hole on the opposite bar to get the headrest to come off.

I hope this helps, and thanks for using Fixya.

Dec 11, 2010 | 2006 Ford F-150

2 Answers

Remove chyrsler town & country headrest


Pull the headrest all the way up. Where the two rods go down into the seatback you will see a small hole in each of the plastic mounts. All you have to do is push a paper clip into the hole and lift theb headrest up to remove it. Do this for each rod. To reinstall just push the rods back in. Thanks for visiting I hope I solved the problem for you.

Nov 19, 2010 | 2010 Chrysler Town and Country

2 Answers

How do I remove the headrest from the front seats so that I can put seatcovers?


there should be a button you push in under the headrest on the top of the seat

May 08, 2010 | 2007 Pontiac Montana

2 Answers

I want to put seat covers on my 2009 Impala. Is


There is a pinhole on one side. Use a paperclip to push the locking clip in and it will pull up and out

Jan 16, 2010 | 2009 Chevrolet Impala

1 Answer

Removing the electrical wiring from the egr valve on 2005 dakota


The red clip should just be a lock for the connector pull it out then you should be able to unplug the connector

Mar 26, 2009 | 2004 Dodge Dakota

Not finding what you are looking for?
2005 Dodge Dakota Logo

Related Topics:

594 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...