Question about 2001 Honda Odyssey

1 Answer

Seat Sliding switch malfunction

Can I just replace the seat switch on the drivers side. My seat will slide every way but back. Occasionally it works after much perseverance.
Do you have a solution or part number?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Honda Master
  • 1,348 Answers

It may be the seat motor assembly.any honda dealer can get you the switch.check and make sure nothing is jammed in the track under the seat

Posted on Jul 13, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Who do I remove rear seat for a BMW 760li?


Most rear seats need to be unlatched from the very bottom on each side. Try sliding the driver and passenger seats fully forward. With your back against the front seat press forward toward the trunk on the bottom of the rear seat on one corner at a time near the floor and lift up. This should release the latch. To replace the seat simply slide the seat back into place with the front slightly raised upward and push the seat in toward the trunk then push down til you hear the latch catch.

Nov 15, 2014 | 2004 BMW 760Li

1 Answer

Town and country 2005 key fob will not unlock front doors. It will however open the tailgate??


do you have a second fob try it battery may be low may need reprogramed or replaced check with your dealer

Jul 07, 2012 | 2006 Chrysler Town & Country

1 Answer

Have a 1999 Chevy 1500 extended cab. Driver seat is not powered. Won't lock into place, keeps sliding back and forth. Was told I have to replace the whole seat and sliding track by Chevy Dealership. Anyone...


Remove the seat assembly turn it upside down cables come off the handle you pull on to slide seat, Follow these cables to 2 pawls that pivot on tracks and see if they are broken,bent,or just stuck and need cleaned and lubed.If you need new track slider assembly I use to be able to get them all the time from GM parts department and just replace tracks themselves.

Dec 23, 2009 | 1999 Chevrolet C1500

1 Answer

2ooo ford explorer driver side electric seat will not work can you please help


check owner manual for location of fuses and relay that control seat. it has 2 motors, one for the seat back & one for the sliding back & forth. If one works, suspect motor. If both don't work, suspect fuse or relay.
Also, check wires for chafing under seat, they can get cut if out of position.
report back.

Dec 12, 2009 | 1993 Ford Explorer Limited

2 Answers

2003 Toyota Camry drivers side power seat stuck


This is not necessary...as many have stated...use a hammer with switch in reverse position. Hammer the seat back...it will catch...

Aug 25, 2009 | 1992 Toyota Camry V6

1 Answer

1999 Pontiac Montana passenger sliding door stopped working.


Verify the wiring harness which passes under plastic step & carpet at front passenger side. This wiring harness goes from the firewall to the pillar on the right side and some have crimped connectors in them to act as junction between two or more wires (ususlly the 12volt feed), which deteriorate with time, especially with Salt & Water. Then the electric sliding door stops working and even driver the electric seat can loose power.

May 17, 2009 | 1999 Pontiac Montana

2 Answers

My driver side power seat will not move forward or back. Up and down, and recline still work. Is this most likely a fuse, motor, or switch problem?


hello dschlig, most common for these seats are the motors. I would recommend raising the seat as high as possible. While trying to activate the seat in the forward/back positions, see if you hear or feel a clicking in the motor under the seat. The motor can be recognized closest to the carpet, and has 2 rods going to each seat track. If the motor clicks, inspect the connector and make sure nothing dislodged it. If it is ok, you can use a small hammer and an extension and lightly tap the motor to see if it will maybe release. If you know how to use a volt-meter, you can also check for power to the motor connector when sliding the switch in either direction. The motor can be replaced seperately.

Apr 08, 2009 | 2001 BMW 3 Series

1 Answer

The drivers power seat in my 2000 Chevy Silverado is sliding


The problem is probably due to some shims in the seat rails that have "dissolved". I have posted a video on YouTube that shows what I needed to do to repair my seat. http://youtu.be/sOjivYnXMAQ

Feb 03, 2009 | 2000 Chevrolet Silverado 1500

1 Answer

The lever to move the driver's seat forward and backward doesn't


The reason is that your sliding grips have been slipped and therefore jammed at one position.

Remove the seat open it's sliding grips and replace it.

Jan 28, 2009 | 2002 Nissan Pathfinder

1 Answer

Security system?


Sounds obvious,but have you tried moving the security switch (at the base of the parking brake) to the off position.

If that does not work, your security system is prob faulty and you should disengage it. Check your owners manual on how to do this. There should be a separate security system manual with the directions to disengage the alarm.

If you cant find it, and you absolutely must fix this prob. You can remove the alarm control unit underneath the driver side seat. You'll have to take out the drivers seat (Easy: just unscrew the 4 screws attaching the seat to the frame, start with the 2 in the back by sliding seat all the way forward, then slide seat back and remove front 2. The control unit is the unit next to the console. just unplug it and leave it in there just in case you need it later for something. Good luck

Jan 19, 2009 | 1995 Nissan Pathfinder

Not finding what you are looking for?
2001 Honda Odyssey Logo

Related Topics:

195 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...