Question about 2002 Isuzu Rodeo

2 Answers

Won't crank, will push start and runs fine.

My 2002 isuzu rodeo 2wd 4cyl won't crank, when I turn key all lights come on as normal, but won't crank. It will push start and runs after it is started. replaced crank shaft sensor, as that code was showing from the check engine light.

Posted by on

  • 3 more comments 
  • father081104 Jul 13, 2009

    Checked battery, took out starter and had tested and was fine.

  • father081104 Jul 13, 2009

    Checked battery, took out starter and had tested and was fine.

  • father081104 Jul 13, 2009

    had starter tested at the store, they said it was good. Replaced crank shaft sensor but that didn't do it. Put starter back and took a test light and can't find a problem.

  • father081104 Jul 13, 2009

    Could it be the clutch start switch? Reading manual, but it does not say where this is located, only that it is part of the starting system. Please help. How do I check this and where is it?

  • father081104 Jul 13, 2009

    Could it be the clutch start switch? Reading manual, but it does not say where this is located, only that it is part of the starting system. Please help. How do I check this and where is it?

×

Ad

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 77 Answers

You may have a bad starter. It'll run after you push start it because it's not using the starter to crank the engine. If you bring it the starter, some auto parts stores will test your starter for you.

Posted on Jul 13, 2009

  • Bassplyr
    Bassplyr Jul 15, 2009

    Doing my best to help you with this one. The clutch pedal starter switch is a definite possibility.

    I'm not too sure of it's location, but I would start by looking under the dash by the top of the clutch pedal. Most likely that is where it is. Another possibility could be your ignition switch, but I would test the clutch pedal starter switch with an ohm meter first.

×

Ad
  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 3 Answers

Make shure your baterie haves abaut 13 amps
then check your starter solenoid make shure that curent is geting there wen you turn the key

Posted on Jul 13, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have a 2003 Isuzu rodeo 6 clyinder 4wheel . Starter turns over a little longer before cranking. Done tune up, changed out fuel regulator but still dose the same ,what is my problem . t


a little longer before cranking.

what does that mean?

dont crank,
cranks slow.
cranks (Fast) called normal.
cranks fast starts, then stalls.
cranks fast, starts easy, starts, runs and stays running, normal
at what point does it fail, and how exactly.

we can't hear it, or watch you, so...................................

Dec 13, 2015 | 2003 Isuzu Rodeo

1 Answer

Good day, I have a 2001 Isuzu Rodeo LS 2WD, manual transmission. A week ago I started having problems starting my truck, seems like the ignition switch was not working, I have to crank it up to four t


Could be your fuel pump failing. Try this; turn ign key to "on", not "start" then off after 5 seconds. Do this several times then try "start". If it starts right up this time, your fuel pump could be going bad, or the fuel pressure is dropping for whatever reason.

Oct 30, 2014 | 2001 Isuzu Rodeo

1 Answer

93 rodeo 3.2 2wd crank but no start


What happened when it stopped running in the first place? You might want to verify the cam/crank position if you can. If you jumped a tooth or have a stretched belt, you are going to have valves open when you are supposed to be firing off on the compression stroke. A compression tester on the number one cylinder would be one way to test it, or a leak down tester.

Mar 06, 2014 | 1993 Isuzu Rodeo

1 Answer

Cylinder head bolt tightening sequence for isuzu rodeo 1998


1998 Isuzu Truck Rodeo 2WD 2.2L MFI DOHC 4cyl

The Head Bolt Torque

Torque sequence ----------------- front ' 7 3 1 5 9 ' of ' ' engine ' 8 4 2 6 10 ' ----------------- Step 1: torque bolts in sequence to 18 Ft/Lbs Step 2: turn bolts in sequence an additional 90-degrees Step 3: turn bolts in sequence an additional 90-degrees Step 4: turn bolts in sequence an additional 90-degrees recheck final torque in sequence

1998 Isuzu Truck Rodeo 2WD 3.2L MFI DOHC 6cyl

The Head Bolt Torque

Torque sequence -------------- front ' 6 1 3 7 ' of ' ' engine ' 5 2 4 8 ' -------------- Step 1: torque to 20 Ft/Lbs Step 2: torque to 47 Ft/Lbs recheck final torque in sequence

Jan 15, 2013 | 1990 Isuzu Spacecab

1 Answer

Engine will not start after changing battery in 2004 Isuzu Rodeo


Get yourself a can of starting fluid spray, and spray NO MORE than a two second burst into the air intake after removing the filter. Then crank it. If it fires (very briefly), your problem is low or no fuel delivery to the engine.

May 16, 2017 | 2004 Isuzu Rodeo

2 Answers

Full trottle when i start my 4cyl rodeo it,s a 4cyl manual tran


check throttle linkage i think you'll find it stuck wide open.

Nov 16, 2008 | 2000 Isuzu Rodeo

2 Answers

ROdeo 2002 wont crank, headlamps do not turn on, fuel gauge shows empty


It sounds like your Starter ... That is if it does not crank at all of course.

Aug 05, 2008 | 1998 Isuzu Rodeo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

441 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14384 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...