Question about 1998 Honda Civic

1 Answer

98 honda civic dx wont start

Wont start

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 84 Answers

If engine cranks, replace main relay, if no crank, replace ICM.

Posted on Jul 15, 2009

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

jeremythious
  • 37 Answers

SOURCE: 91 honda civic dx. Starts, runs for a few seconds then stalls

Try pounding on the gas tank with a rubber mallet or similar tool. (careful not to dent the tank) Try starting it. If it runs, replace the fuel pump (it's nfg). I've diagnosed numerous fuel pumps this way. Remember the pump needs to be replaced, if you drive it, you don't know when it'll fail for good. Hope this helps. Please post the results.

Posted on Feb 08, 2009

blueextc3221
  • 15935 Answers

SOURCE: How to change upper control arm on 1996 Honda Civic DX ?

UPPER CONTROL ARM:

Do not disassemble the upper arm. If the ball joint or bushings are faulty, or the upper arm is damaged, the entire upper arm must be replaced.

  1. Raise and support the vehicle safely.
  2. Remove the front wheels. Support the lower control arm assembly with a floor jack.
  3. Separate the upper ball joint from the steering knuckle using a ball joint separator tool.
  4. Remove the self-locking nuts from the upper arm anchor bolts. Remove the upper arm from the vehicle.

Do not disassemble the upper arm. If the ball joint or bushings are faulty, or the upper arm is damaged, the entire upper arm must be replaced.
To install:
Use new self-locking nuts when installing the upper arm and strut.
  1. Install the upper control arm assembly into the strut tower.
  2. Connect the upper ball joint.
  3. Install the front wheels and lower the vehicle.
  4. With all four of the vehicle's wheels on the ground, torque the upper control arm nuts to 47 ft. lbs. (65 Nm). Torque the castle nut to 32 ft. lbs. (44 Nm); then, only tighten it enough to install a new cotter pin.
  5. Tighten the wheel nuts to 80 ft. lbs. (110 Nm).
  6. Check and adjust the vehicle's front end alignment.
The bushings on the front lower control arms are replaceable on most models.
This procedure requires the use of a press and may be above the skill range of the average driveway enthusiast. It is recommended that this procedure be done by a qualified machine shop if you are not skilled in the proper use of a press.
  1. Remove the lower control arm that is in need of new bushings.
It is recommended that both the left and right lower control arm bushings be replaced at the same time. The vehicles handling may become unstable if there are new bushings on one side of the car and worn ones on the other.
  1. Set up the control arm in a press.
  2. Using a impact socket of the correct length and size, press out the old bushing.
  3. Install the new bushing by slowly using the press to push it into the control arm.
  4. WARNINGExcessive force could cause the bushing to bend or tear so be careful.
  5. Once the bushing is properly seated in the control arm, remove the arm from the press and install it on the vehicle.

Posted on Apr 05, 2009

  • 713 Answers

SOURCE: 1996 honda civic dx interior dash lights turn, headlights on.

it is more than likely a short in the headlight switch. also try the dimmer switch on the dash for the dash lights.

Posted on Aug 27, 2009

  • 34 Answers

SOURCE: my 98 honda civic Lx wont shift into gear

check your shift linkages if the bushing is worn out you may have problems shifting or it could be a bad transmission

Posted on Dec 26, 2009

  • 112 Answers

SOURCE: were is the main relay located

under the hood on the left passenger side

Posted on Apr 16, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the crank trigger located on a 98 Honda civic dx 1.6 sohc engine,Thanks


The crank and cam sensors are integrated into the coil / distributor assembly.
>

Feb 19, 2015 | 1998 Honda Civic

1 Answer

My 2001 honda civic dx wont start


installed a 2004 transmission in a 2001 honda civic but the enginge wont start the fan comes on and the drive light on the gear shift contanly blink in all other gears.

Apr 03, 2010 | 2001 Honda Civic

1 Answer

My 1994 honda civic dx died while i was driveing it and now it wont start back up the engine turns over but it still wont start


Fuel pump could be issue. Check for spark from plugs and see if you can here you fuel pump prime when you put the ignititon from off to run but not start. Should hum for a few seconds and quit.

Jan 14, 2010 | 1994 Honda Civic

1 Answer

My 98 honda civic Lx wont shift into gear


check your shift linkages if the bushing is worn out you may have problems shifting or it could be a bad transmission

Dec 25, 2009 | 1998 Honda Civic

4 Answers

Honda 1992 Civic DX 1.5L water pump diagram on How to take off. Do you have any FREE please


In order to replace the water pump you would have to do the timing belt. Don't know if you are aware of how involved and the kill level it requires.

Nov 05, 2009 | 1992 Honda Civic

1 Answer

Broken lug nut stud on 98 civic dx coupe


knock it out... use an old nut that will fit the new stud and install the stud. the nut will pull the stud in tight to the flange.

Jul 19, 2009 | 1998 Honda Civic

1 Answer

98 civic dx no ac


If it had it one time or another yes. If not it will cost u a lot of cash.

Jul 07, 2009 | 1998 Honda Civic

2 Answers

My 97 honda civic dx check engine light keeps coming on


Had this issue did you replace the exhaust

Jun 19, 2009 | 1997 Honda Civic

Not finding what you are looking for?
1998 Honda Civic Logo

Related Topics:

611 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...