Question about 1997 Isuzu Trooper

1 Answer

Cylinder 2 missfire detected

In this Isuzu trooper 97 i scan the suv and the results is cylinder 2 missfire detected. i chance sparks to platinum i switch the square thing that goes on top. to another cylinder and still the same problem.. cyl 2 missfired detected. some guy told me i could be a valve that is bended or something like that but for me is something electrical.. can sombody please help me... the engine is the v 6

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 108 Answers

Get a Compression tester.Its easy to do. Remove the plug and screw this in to the spark plug hole and disable the ignition system by pulling the ECM fuse. Crank the engine for 5 seconds and stop. Check the gauge. It should show 150 psi or close to it. If it shows under that check some of the other cylinders and see if they read the same thing. If they give a better reading then you could have a bent valve, a blown head gasket or broken rings or even a hole in the piston. If your unsure then take it to a shop and have them run a compression test on it for you. And make sure you stay in the shop while they do it and see the reading for yourself.

Posted on Jul 13, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is the firing order of isuzu trooper 97 v6, where do i start from ignition coil and from engine block?gasoline because i interchange the coil cable of #6 and#3


really easy 123456 ,counter clockwise you can see it for your self at autozone library its all free and no spam, with the fan facing you first cylinder to your left is #1 first cylinder to your right is #2 it dosent matter where you start as long as you follow the firing order

Feb 26, 2015 | Isuzu Cars & Trucks

1 Answer

Missfire on cylinder n 2 p0302/po316


MISFIRE ON CYLINDER 2 COULD BE LEAKING INTAKE AT CYLINDER 2 OR DIRTY CLOGGED FUEL INJECTOR AT 2 CYLINDER.REPLACE AIR FILTER IF IT LOOKS DIRTY AND CLOGGED UP AND CHECK TRANSMISSION FLUID LEVEL.IF FLUID LOOKS BURNT SMELLY CHANGE FLUID AND FILTER.

May 17, 2010 | 2003 Ford Taurus

2 Answers

Spark plug leads order of firing


Hi!!


Firing order 4 cylinder engine 1-3-4-2 --------- front | | of | 1 2 3 4 | distributor rotates counter vehicle | | clockwise ---------

Firing order 6 cylinder engine 1-2-3-4-5-6 ------- front | 1 3 5 | of | | Distributor rotates clockwise vehicle | 2 4 6

Appreciate if rate this post, Good Luck!!

Apr 26, 2010 | 1991 Isuzu Trooper

2 Answers

Check engine light flashing runs rough not firing on all cylinder2000 lincoln navigator with large triton engine Hooked up diagnnostic and it said 1. system too lean bank #2 2. Unable to bleed up fuel tank...


you may try your rotor button and distributor cap. and spark plug wires. try your map sensor also they tend to cause a lot of misfiring if they go bad.hope this helps.

Apr 20, 2010 | Lincoln Navigator Cars & Trucks

1 Answer

Cylinder 6 missfire detected


if its just one cylinder missfiring its in the wire / coil pack replace plug then try the others good luck

Jan 08, 2010 | 1997 Isuzu Trooper

1 Answer

97 isuzu hombre cylinder 2 misfire


1998 isuzu rodeo wont start no spark,no injector pulse

Jan 08, 2009 | 1997 Isuzu Trooper

4 Answers

Diagnosing a misfire


good luck i have the same car and it has been a nightmare from day one . everything is expensive to repair mine showed a mis fire in same cylinder had to supposedle head gasket was bad and gas was gettting in causing misfire

Aug 15, 2008 | 1997 Isuzu Trooper

1 Answer

Hesitstion and miss firing till it warms up just replaced oxgen sencor and coils


my 97 maxima had was hesitation and cylinder #5 had a missfire changed my spark plugs to ngk platinum plugs, it runs perfect now........try checking your plugs

Jul 16, 2008 | 1997 Nissan Maxima

1 Answer

Cylinder number for firing order for 1995 Isuzu Trooper


Hi,

Assuming your 1995 Isuzu Trooper is using the 3.2 SOHC engine, the firing sequence would be as shown here.
351636c.jpg. This was originally posted here. An actual image 47d297f.jpg which was originally posted here.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FixYa.

Jun 16, 2008 | 1995 Isuzu Trooper

Not finding what you are looking for?
1997 Isuzu Trooper Logo

Related Topics:

140 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...