Question about Dodge Grand Caravan

1 Answer

My 2001 dodge grand caravan's new water pump is not fitting between the fram and engine block. The old one came out with no problem. Is there a trick to getting it in?

Posted by on

  • Mike Butler
    Mike Butler May 11, 2010

    What engine? 3.0L.3.3L, or 3.8L

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Slide the pulley behind the 3 tabs that the bolts go inthen it will fit

Posted on Aug 21, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What type of engine coolant do i use for a 2008 dodge grand caravan


Should be in the owners manual & maybe on a
sticker under the hood

Seeing as how you can not buy the old green stuff any more
& you surely don't use GM Dexcool which by the way is 85%
of all the coolant on any shelf out there

The one size fits all,not in my vehicles

Yellow Prestone at wal mart & everywere else
Read the back,same chemicals as dexcool

Answer: 2001 or 2002 on---Zerex G-05 Coolant

Mix 50/50 or my preference 60/40 with Distilled
Water from supermarket

NEVER tap water- too many minerals & other things
that do not go in a coolant system

Jul 15, 2014 | 2008 Dodge Grand Caravan

2 Answers

Can;t get the old water pump off and new one in


you need to remove the pump and install the pump with the pulley bolted on

Aug 25, 2012 | 2005 Dodge Grand Caravan

1 Answer

Where is the crank shaft sensor on a 2001 dodge grand caravan


I think it is on the lower side of the block around your oil filter, I think. If you get the new one just look for something similar on the side of the block. Good luck

Jun 11, 2010 | 2001 Dodge Grand Caravan

2 Answers

Need step by step to replace water pump on 1997 dodge caravan v-6 3,0 mits. motor...


Chrysler Caravan/Voyager/Town and Country 1996-1999 Water Pump - REMOVAL & INSTALLATION
3.0L Engine
See Figure

a812cd7.jpg

Fig. 3: Water pump mounting detail-3.0L engine
  1. Disconnect the negative battery cable.
  2. Drain the cooling system.
  3. Remove the drive belts. Remove the timing belt covers and the timing belt.
  4. Remove the water pump mounting bolts.
  5. Separate the water pump from the water inlet pipe and remove the water pump.
  6. Inspect the water pump and replace as necessary.

To install:
  1. Clean all gasket and O-ring surfaces on the water pump and water pipe inlet tube.
  2. Wet a new O-ring with water and install it on the water inlet pipe.
  3. Install a new gasket on the water pump.
  1. Install the pump inlet opening over the water pipe and press until the pipe is completely inserted into the pump housing.
  2. Install the water pump-to-block mounting bolts and tighten to 20 ft. lbs. (27 Nm).
  3. Install the timing belt and timing belt covers. Install and adjust the drive belts.
  4. Reconnect the negative battery cable. Fill the cooling system to the proper level with a 50 / 50 mixture of clean, ethylene glycol antifreeze and water.
  5. Run the engine and check for leaks. Top off the coolant level, if necessary.

Hope this help (remember comment and rated this).

Apr 13, 2010 | 1997 Dodge Grand Caravan

2 Answers

How do you remove the water pump from a 2006 dodge grand caravan 3.3 v6


drain coolant loosen water pump pulley bolts, take off serpentine belt, finish removing pulley, unbolt water pump (5 bolts) and remove scrap off old gasket silicone new gasket to new water pump and reverse steps for installation

Oct 22, 2009 | 1996 Dodge Caravan

2 Answers

Labor time to replace a faulty water pump in 05 Gran Caravan 3.8


Try (repairpal.com) for estimate for your particular area. You may have to enter Grand Caravan to get the 3.8L engine .
I'm thinking 2 hrs.

Oct 05, 2009 | 2005 Dodge Caravan

1 Answer

2005 Dodge Grand Caravan 3.8 liter engine needs water pump replac


3.3 & 3.8 same block. V6 no special tools needed

Sep 29, 2009 | 2005 Ford F-150

1 Answer

1992 Dodge Grand Caravan engine failure


There is not fuse for pump but a relay in the relay block. I do suggest jumping to see if pump turns on. Test voltage from ECM if needed. If voltage is to pump, then pump is shot. If not voltage, relay may be bad

Sep 11, 2009 | 1992 Dodge Grand Caravan

1 Answer

Will Transmission from 3.0L 1999 Caravan fit 2001 Grand Caravan


yes if they both have the same engine both of those years are interchangeable

May 21, 2009 | 2001 Dodge Grand Caravan

1 Answer

2001 Grand Caravan no heat and occasional over heating.


depends on the engine....a 2.4 requires the removal of the timing belt......on a 3.3 /3.8 the water pump is on the passenger side close to the fire wall.look for an orange or green coored residue in the vacinity of the pump....i would bet its leaking

Oct 04, 2008 | 2001 Dodge Grand Caravan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

288 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...