Clucth not disengauging....

Sounds like a motor mount broke

car is in two gears disengauge linkage and put back in Mistral if is a too loader you may have to pull the shift assembly and manually shift thhe gears your shift forks may be bent

it may be in limp mode if you have a transmission problem check eng light on?

I take it that you have a standard transmission ? there is no adjustment, but on the saturns the plastic insert on the shifter lever (remove the center console) is what breaks, Napa auto parts has the replacement part for about $20, or you can go to saturn and spend $200 on replacing both cables

this caused by a defective climate control system air temperature control blend door actuator motor gear drive slipping and a poss warping and sticking blend door in the ducting, to change these parts requires the dash be remove from the car, both must be inspected

dear friend-i dont believe your problem is gearbox related but more the clucth,a simple test can give you a idea to the problem,switch the engine off then run threw all the gears,check the travel on gear 3 should be the same as 1 and 5 check for obstruction at gear shift on gear,should this test turn out fine then bleed clucth or replace

Get your ECU (comp box) checked, it may be your speed sensor needs replacing, it's what tells your tranny too to shift....

Put the pilot bushing in the crank shaft, install the flywheel. Next put the pressure plate back on, but leave the bolts loose so you can use the plastic alignment tool. Insert it through the pressure plate hole, and into the pilot bushing. Then tighten down the pressure plate bolts, and remove the tool. Install the throwout bearing on the clutch fork, and you are ready to go.

HELLO I HAD THIS SAME PROBLEM ON MY 95 NISSAN ALTIMA AND REMOVED THE PLASTIC COVER THAT AROUND THE SHIFTER AND THE SHIFTER BRACKET THAT MOVES TO PUT THE CAR IN GEAR THAT HOLDS THE SHIFTER CABLE IT WAS RUSTED SO I SPRAYED IT WITH WD40 A FEW TIMES AND MOVED THE SHIFTER BACK AND FORTH A FEW TIMES AND IT WAS FIXED NOW THERE HAS BEEN CARS THAT I HAVE WORKED ON WERE THE SHIFTER HAS DONE THIS AND IT WAS DUE TO THE PEOPLE WHO OWED THIS CAR BEFORE THEM THATS DROP THERE MONEY LIKE CHANGE DOWN IN THERE OR IT COULD BE FROM DIRT TRASH OR GETTING DOWN THERE JAMMING THE SHIFTER GEARS AND MAKING THEM NOT WORK WRIGHT NOW IT IS NOT UNLIKEY THAT THE CABLE MIGHT BE JUST WORN OR STREHCED THEN IT NEEDS REPLACED PLEASE CHECK OUT THESE SOLUTIONS BEFORE REPLACING THE SHIFTER CABLE