Question about 1995 Mazda 626

1 Answer

My son's 95 Mazda626xl drives beautifully but it shakes and stalls when in idle or neutral position Do you know what the problem could be

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 35 Answers

I suggest a tune up, also replace the fuel filter and air filter, the timing is possibly off slightly causing the engine to run rough. Have the timing checked to make sure its not just slightly out of time first

Posted on Jul 12, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Stalls when put into drive or reverse


Your idle air controller may be failing. Begin checking for stored codes using a code reader, and progress to standard troubleshooting steps such as checking spark, fuel delivery, and operation of the intake air control circuit.

May 11, 2015 | 1994 GMC Sierra

2 Answers

Replaced plugs, had a tune up, replaced air filter but still idles high in p&n drive is at around 1000 p&n runs close to 2000. it also runs bad... shakes and if in drive and stopped for to long...


The first thing I would have checked is the TPS, ( throttle position sensor ), this is usually the cause of a high idle.

As far as running bad and fake stalling or stalling, there are 2 very common things that can cause that.

1. MAF, ( mass air flow ), sensor. If this is faulty you will have issues like, bad idle, loss of power when accelerating, poor gas mileage, fake stalling and stalling, eventually your engine will not start.

2. Oxygen sensors. Faulty oxygen sensors can cause very similar symptoms as the MAF.

I hope this helps you.

Feb 11, 2011 | Dodge Stratus Cars & Trucks

2 Answers

2005 Ford Escape, with 165,000 miles, idles fine, starts fine, but when put in drive the engine stalls., put in neutral, cranks right up. rev engine up while in neutral and drop transmission to drive...


I would check your "idle speed control" ISC on the intake manifold. It may just have to be cleaned. An ordinary can of carb cleaner should do the trick if the pintle valve inside is grunged up.

Feb 03, 2018 | 2005 Ford Escape

1 Answer

96 Saturn SC1 (automatic): b 4 installing (CPS) crankshaft position sensor...she ran beautiful...now, rough idle and the moment she's put in gear, she stalls-out. I shimmed the sensor, she runs OK, but...


If it ran beautiful I don't see why you installed CPS. ??? 

The CPS and CAS should only be replaced if the car is stalling or shorting out. I just changed the CAS on my 95 Talon but only because it was cutting off like I turned the key off. 

If the only thing you did was change the CPS then it's not lined up right. Every car is different but the CPS usually has to be aligned.

Aug 07, 2010 | 1996 Saturn SC

1 Answer

Shakes while idling and sometimes stalls.


check for minor vacuum leak and map sensor,pcv,egr valve

Oct 13, 2009 | 2001 Chevrolet Blazer

3 Answers

95 cadillac eldorado engine stalls rough idle check engine light is on


I have a 1994 Cadillac Eldorado and every time i start it the car has rough Idle and the Idle fluctuate's. I also can feel it in the gas pedal when the car is doing this I tried replacing the throttle body sensor but it still does it I also was told it was the Idle error sensor. So instead of spending the unecessary money again I thought I would go online and see if anyone could help me with this problem.

Sep 30, 2008 | 1995 Cadillac Eldorado

1 Answer

1995 940 wagon...stalls...ideas/help...please?


Could be several things; MAF ( Mass air Flow) sensor, (Yes you should have one), could be fuel pump on the rail or the filter next to it, could be electronic idle controler, clogged injectors, ect ect, a Volvo dealer can do some simple checks of the actual components and tell you, but have someone else fix it!

Jun 21, 2008 | 1991 Volvo 940

Not finding what you are looking for?
1995 Mazda 626 Logo

Related Topics:

332 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...