SOURCE: 2006 kia sorento
There are a couple of thing that cause the bulbs to fail, on e and very common is to touch the glass part of them, the oils in the skin will cause the glass to shatter, the other and most common is moisture getting into the headlight, this is easy to detect, the inside of the headlight lens will be fogged out or you will see water inside, ever had water touch hot glass? it shatters, this is caused by leaks in the electric weld seam, the only fiz is to replace the headlight lens assemblies. You can buy these in the after market fairly cheap from Partstrain.com, I have used there parts and they are very good quality.
SOURCE: 2006 Trailblazer Headlight Replacement
There are not two rods, there are two clips one under fender weild and one right above the light on top of the cover. Pull up on these two clips and pull the light forward a couple of inches and remove the dust cover. You have to take the air filter cover off to be able to reach in and replace the light. It took me about 10 min to figure these out but hope it helps out.
SOURCE: Left low beam headlight on Chrysler 2003 T&C wont work while engine is on
Ill guarantee you have an electrical short on the left side of the headlight switch,circuit.From here its immpossible for me to go any further.Good Luck.,Get A Wiring diagram.
SOURCE: how do I align low beam headlight in 2006 honda
The adjustment screws/nuts should be located either on the top of the headlamp assembly,
behind the headlamp assembly, or near the frame rail by the radiator
support.
You will have vertical adjustment screws for each independent beam
(separate highs and separate lows, but will be same screw if highs and
lows are the same bulb). You may also have additional horizontal
adjustment screws as well
Park
your car on a level ground 30 feet from a wall and measure the height
from the ground to the bulb and mark on a wall (do this for highs beams
and low beams if the bulbs are separate, if highs and lows are the same
bulb, only do it for the lows)
For Low Beams: If the headlights read VOR, then
aim the brightest part or cutoff part just below the mark on the wall.
If it says VOL or nothing, aim them 2 inches below the mark on the wall.
For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.
169 views
Usually answered in minutes!
×