Question about 2006 Audi A4

Open Question

How to remove a headlight from a 2005 A4 Audi Avante, Do I have to replace the entire light assembley or just change the bulb ?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
AlmostBob
  • 550 Answers

SOURCE: how do i change the headlight bulb in a 2005 sebring convertable

Lift up the hood, the bulbs are changed from the engine compartment
behind the lamp are connectors, pull it off, and the retainer that holds the bulb in
replace bulb
replace retainer
replace wire
close hood
usually takes longer to type than to do

Posted on Jul 14, 2008

Ad
  • 13 Answers

SOURCE: how replace break light bulb in on a4 2005

Replacement of any bulb in the Tail-light assembly is easier then one thinks.

First thing you need to do is gain access to the trunk area. At the top of
the tail-light area inside the trunk is a small circle that needs to be
opened to expose the bolt that you need to remove.

WARNING: Be careful not to loose this bolt or you are going to have to take
apart your trunk interior to retrieve it.

After the bolt is removed the Tail-light assembly will pull out as follows;
Left side: pull out the right side of the assembly
Right side: pull out the left side of the assembly.
The out side of the assembly is held in place by 2 or 3 small nipples.

There will only be one cable that is connected to the assembly. This does not
have to be removed unless you really want to. On both sides of the assembly
there are 2 clips that hold the light plate to the break light lens. After
the clips are loosened the whole light bulb assembly can be removed and the
bulbs replaced.


Restoring the Break-light assembly.

After you have replaced your bulbs and re attached the the bulb assembly, you
will have to first fit the nipples on the outer side of the assembly then
push the inter side into place. Replace the bolt and tighten. You are done.

Posted on Jul 16, 2008

  • 1 Answer

SOURCE: Audi A4 2003 Change RH frontIndicator bulb

I've just replaced mine so here goes. Undo the top two bolts first. Then remove the two screws above the radiator holding the air intake ducting in place and gently pull out the air intake pipe and move to the back of the engine, exposing the rear of the lightbulb housing. To the rear of the lightbulb housing is a bolt. You should only need to loosen the bolt and this will allow the lightbulb unit to be pulled forward clear of the car. On the back of the housing you will find a cover, remove the clip retaining the cover and fold it away, exposing the rear of the light bulb.

Posted on Oct 10, 2008

  • 2 Answers

SOURCE: How to changing the headlight

Take screws off the front cover about 10-20 screws Reemove cover then two screws by the headlight Pull wole healight out, Repalce bulb. Not that hard. Read the manuel. My 16 year old did it with her Dad

Posted on Dec 31, 2008

j_del
  • 1586 Answers

SOURCE: 2000 Audi a4 headlight bulb replacement

The easiest way to do it is to pull the headlight out of the car. This isn't hard, but you'll have to have a T30 Torx bit to do it. There are three bolts that secure the headlight. Two are on top of the headlight - you'll see them right up there on top when you open the hood.

The third is harder to find. Look where the outer upper corner of the headlight meets the top of the fender, above the corner indicator. There is a lip on the fender that runs all the way back to the base of the windshield, where the edge of the hood sits when it's closed. There is a round hole in that lip near the headlight (just behind it). Shine a light down in there and you'll see the third Torx bolt. Take that out and you can slide the headlight assembly forward. You shouldnt' have to take it fully out of the car, just take the bolts out and move it forward.

Then remove the dust cap on the back of the headlight, pop the connector off the bulb, undo the spring clip holding the bulb, and remove it. Install the new bulb (wipe down the glass portion with your t-shirt to get any skin oils off it, as they'll burn it up quickly), and then reassemble in the reverse order.

Posted on Jan 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 05 Audi a4 the headlights, tail lights, brake lights and windshield wipers want work what could be the problem?


have you checked your fuses headlights ,tail lights and brake lights are all on one fuse .then if the fuse is ok check to see if the bulbs are all ok.better still replace them.and then do the same as for the fuse for your wipers

Jun 10, 2015 | 2005 Audi A4

Tip

How To Install Replace Change Headlights and Bulbs 2005-08 Audi A4


Learn how to install or replace the headlights and bulbs on a 2005-08 Audi A4

on Jan 27, 2016 | Audi Cars & Trucks

1 Answer

Replace parking light bulb


Check the headlight assembly for 3 mounting bolts...some models it is best to remove the hold down bolts for the entire assembly, then remove and replace the parking light bulb...carefully do not touch the new bulb as the human moisture will shorten the life of the new bulb...Hope this helps.

Jan 28, 2013 | 2004 Audi A4

1 Answer

How do I replace a Parking Light on a 2005 Audi A4?


Hi. Here's how to remove the bulb. Remove the two screws and air intake duct. There is a round door on the side of the headlight assembly. Push down the tab at the top to open and remove it. Turn and remove the DRL bulb. I had to use pliers. Then wiggle and pull the parking light bulb straight back

Aug 09, 2010 | 2005 Audi A4

1 Answer

2004 Audi A4 passenger side headlight bulb gone. Is it possible to replace myself as the manual says go to dealer. If so how? Many thanks Mike


You need to take the headlight unit out if its on the left hand side (due to power steering reservoir, if on the right hand side you can just about get to the cover to remove it...
If you need to remove the head lights .. it simple... 4 torque screws on the top.. undo and slide towards youself.... (place on something soft and remove the plastic cover and change bulb.. reinstall and tighten )

Nov 11, 2009 | 2003 Audi A4 Cabriolet

1 Answer

How do you change a front right park light on an audi A4 2003


The easiest way is to remove the headlamp assy.  To do this removed air duct on RH side. remove 2 philips screws and pull up on other end at air filter box.  Next you will see 2 Torx T30 bolts that are holding to headlamp mouting brackets.  remove these completely.  Get a flashlight and look down inside eng bay you will see 2 more mouting points w/ t30 bolts.  loosen but dont entirely remove these.  Slide headlight out.  The park light socket has a big fin style tab grab firmly and twist counter clockwise.  Be sure after removing the bulb that the socket contacts aren't burnt up.  If they are you need a new socket and bulb.  Before reassembling test lights to make sure they work properly and install in reverse order of removal. 

Apr 25, 2009 | 2002 Audi A4

1 Answer

Audi A4 "left dipped headlight" problem


this most likely caused by a poor headlight ground, check around the headlight for any loose wiring that is screwed to the sheet metal of the car under the hood behind the headlight.

Mar 24, 2009 | 2005 Audi A4

1 Answer

Audi A4 "left dipped headlight" problem


AUDI A4- 2005. There is a technical service bulletin for this exact problem. take it to the dealer when this issue has happened while driving. During a daytime drive when cold see if you cant get the light to fail while circling your dealer. As soon as you pull into the service drive do not turn the car off do not flip the switch. I am an Audi Technician for a dealer in Birmingham alabama. Personally this is not my favorite repair to perform; What audi states is that if the bulb flickers the bulb should be replaced; if one side fails the bulb should be swapped left to right if the fault continues with the bulb the bulb is at fault; if the bulb is swapped and the bulb fails again on the same side it is the module. NOW: I currently am working on a 05 A4 that both bulbs both modules have been replaced and Audi has no clue what to advise on a repair. THIS IS AN ISSUE if it has happened to you ask if there is a TSB for this issue or try to find it for yourself.

Dec 09, 2008 | 2005 Audi A4

2 Answers

2000 Audi a4 headlight bulb replacement


The easiest way to do it is to pull the headlight out of the car. This isn't hard, but you'll have to have a T30 Torx bit to do it. There are three bolts that secure the headlight. Two are on top of the headlight - you'll see them right up there on top when you open the hood.

The third is harder to find. Look where the outer upper corner of the headlight meets the top of the fender, above the corner indicator. There is a lip on the fender that runs all the way back to the base of the windshield, where the edge of the hood sits when it's closed. There is a round hole in that lip near the headlight (just behind it). Shine a light down in there and you'll see the third Torx bolt. Take that out and you can slide the headlight assembly forward. You shouldnt' have to take it fully out of the car, just take the bolts out and move it forward.

Then remove the dust cap on the back of the headlight, pop the connector off the bulb, undo the spring clip holding the bulb, and remove it. Install the new bulb (wipe down the glass portion with your t-shirt to get any skin oils off it, as they'll burn it up quickly), and then reassemble in the reverse order.

Nov 20, 2008 | 2000 Audi A4

2 Answers

Headlight change


it is actually quite easy and it will not require tools, but you have to remove the entire headlight assembly.

Open the hood and as you look at the top of the headlight assembley you should notice two tabs, you will need to pull these up and then remove the assembly. Once it is out you will be able to unplug the wires from the lights and then remove the bulb.

Replace the bulb, the wires and then reassemble, make sure that the tabs are pressed all the way down once finished and you are done

Oct 09, 2008 | 2005 Isuzu Ascender

Not finding what you are looking for?
2006 Audi A4 Logo

Related Topics:

375 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Marvin
Marvin

Level 3 Expert

81400 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14423 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...