I think is the right way and you can do...
1994 to 2003 Chevy 10 GMC 15 Blazer and Jimmy Door Hinge Pin Replacement this should help you
1994 to 2003 Chevy 10 GMC 15 Blazer and Jimmy Door Hinge Pin Replacement this should help you
×
SOURCE: 2001 Blazer door hinge pins and bushing replacement
you need a special spring compressing tool to remove and reinstall the hinge spring and then its a matter of removing the door installing the new bushing and rehang the door with new pins ive tried doing this while leaving the door on the car trust me its just harder that way good luck and please rate -jeff
SOURCE: I have a 98 gmc jimmy. The bushings on the door
I USE A PRY BAR TO GET THEM OUT. GETTING THE SPRING BACK IN DOES CALL FOR A SPRING COMPRESSOR. YOU SHOULD BE ABLE TO GET ONE FROM A AUTO PARTS STORE, MAC TOOLS OR SNAP ON TOOLS.
SOURCE: I need to replace the door hinge pin and bushing
yes you have to remove the door ... the pin have a C washer lock at the bottom. electircal wires are to be unpluged from inside the door or at the driver kick panel
SOURCE: how to replace door hinge pin and bushings without a spring compr
Harbor Freight has the tool for $3.99. I just bought one last Friday and replaced my hinge pins this weekend on my 2000 Chevy Blazer. You have to get that tool. Online they are $15.00. Make sure you support the door before you take out the old pins. I just lowered the window, took rope and tied it to the garage rafters and was all set. have fun!
SOURCE: My drivers side door drops every time I open my
the hinge pins rides on brass bushings. if the door does not latch replace the pin and bushings with oversized ones available at Chevrolet parts department
you will need a sring compressor which is available at Auto Zone
333 views
Usually answered in minutes!
you need a flat screwdriver a pair of vice grips and a hammer and something to set the door on . there is a lock on top flat screwdriver to pop it off take vice grips and put them on the middle of pip and hit it down to pop the pin out and do the bottom same way pin goes up throw pull door out about 3 to 4 '' put bushings in then put back together
×