Question about 2000 Ford Focus

1 Answer

Ford focus wont tickover

1400cc when does tickover foot to floor revs drop down and stalls engine

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 60 Answers

Fuel problem

Posted on Jul 12, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Engine has rough engine at 1250 revs, tickover is fine and over that is ok too, sometimes cuts out at junctions


Start with cleaning the throttle body, idle air control motor, and MAF sensor. After that, tune up.

Sep 24, 2016 | 2003 Ford Focus

1 Answer

I have this problem with my K Reg Audi 80 1.9 tdi...Driving along say 50mph in traffic, take foot from throttle due to traffic flow, put foot back on throttle and nothing happens unless you either let...


you car is fitted with a "no fuel"system,so when you take your foot off "no fuel" goes to the engine untill it reaches 1200 revs.then it will allow fuel to flow to keep tickover/smoothness.(its computer controlled)you need to get your car onto the diagnostic computer,(skoda/seat/vw/audi)so you have the codes/items that need to be sorted.The tdi engine was one of the first engines that VW computerised and it is very reliable/powerful,compared to the peugeot/citroen engine.(briefly,the fault is not just a switch/cable),

Nov 27, 2010 | 1988 Audi 80

1 Answer

I have 4A-FE Motor but if i run the air conditioning RPM counter down to 0.8 ???


the power drain with a/c is about 25% so you would expect a drop in revs at tickover,but the engine electronics will keep tickover to about 800 to 1000 depending on ambient/start temp. nothing to worry about.
if you had a 4ltr engine the drop would be next to nothing......but the fuel consumption.........

Jul 08, 2010 | 1996 Toyota Corolla

2 Answers

When idle the engine revs up and down by its self


my 1990 toyota starlet idles fine its when i put my foot on the throttle it revs up then drops down by itself even when my foot is to the floor

Mar 30, 2010 | 1999 Mercury Cougar

1 Answer

Problems accelerating


the engine tickover is too slow when the engine is cold its running on cold start, ie:choke,, after it warms up the engine slows down this is what is causing it to stall in gear,, get some one to hold the brakes hard on and with the engine running in gear ajust the tick over till its reving at 750 - 850 rpm the revs will go up a bit when its out of gear,, before you pick a gear to go into push the foot brake down to stop the car lurching,,,

Feb 19, 2010 | 1997 Cadillac DeVille

1 Answer

Focus 1.4 zetec idle tickover is about 2000rpm


sensor problem,without the right equipment it will be cheaper to put it in the dealers

Jul 09, 2009 | 2000 Ford Focus

2 Answers

Escort 1998 1.8 zetec mis firing


Hello, did you try changing your coil pack

Feb 07, 2009 | 1996 Ford Escort 4 Door

1 Answer

Ford falcon stalls with ac on


the engine puts out 'X' horesepower....the combination of A/C on demands and turning the wheel..(putting major pressure on power steering system and its belt) ..kills the motor ..its normal..dont do those things at same time anymore

Nov 09, 2008 | 2000 Ford Focus

Not finding what you are looking for?
2000 Ford Focus Logo

Related Topics:

213 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

gerry bissi

Level 3 Expert

4376 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...