Question about 2005 Cadillac SRX

1 Answer

How do you replace the front park light on a Cadillac SRX 2005

Posted by on

  • lakvar Jul 12, 2009

    First I have to check this out. Then I'll know if it was helpful. So far,I think you are right.
    I have never seen such idiotic design before. On most cars your six years old child could change this bulb. Thanks very much.
    lakvar.

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 10,515 Answers

Hi,

First you start with a lot of patience! You have to remove the bottom plastic cover that runs along the front grill. It comes off easily as you pull on the "push pins" that hold it in place. After that is slid out you have to remove the plastic piece inside the wheel well. It is held in place with the same push pins but for some reason there are two sizes but there are obviously different.
Once both of these pieces are out you have to use a 9/32" wrench or socket to remove two bolts. One is on the bottom (6 o'clock position) and the other is on the inboard side (9 o'clock position). The one at 9 o'clock is a bear to get out since it requires either a long reach wrench or freakishly small hands!
When those are out then the whole lamp assembly will drop down. You then need a torx driver (don't know what size since I lost patiernce before I finsihed and took it to the dealer) but once you take out six torx screws you can replace the bulb.
Then simply repeat the process backwards and you are finished!

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!


Posted on Jul 12, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to remove the engine top plastic shroud from 2005 cadillac srx


hEY mELVIN WAS YOUR SRX LIGHT GREEN AND TRADED AT GOLD COAST, COUSE i BOUGHT IT AND it seems to have a few probs, any help Id appreciate...

Mar 27, 2012 | 2005 Cadillac SRX

1 Answer

Replacing the fuse for 2005 cadillac srx back up lights


Hello! In the Left Rear Fuse Block is the Reverse lamp fuse (10A)....The Reverse lamp relay is also located in that box...If the fuse doesn't fix it replace the relay...The relay is low cost....$6...See picture below...guru...saailer


12_13_2011_1_08_47_am.jpg
ACDELCO Part # D1755A

I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867

Dec 12, 2011 | 2005 Cadillac SRX

1 Answer

I have a 2007 Cadillac SRX. Today my engine light came on and it says Engine Powe Reduced. What causes this.


My 2005 came up with this also, it continually became more frequent. Had to replace the throttle body.

Jul 10, 2011 | 2005 Cadillac SRX

1 Answer

My 2005 cadillac srx is stuck on park, how do you de-activate it


hi i have a 2004 cadillac cts that is stuck in park when the ing key is turned on the ing sencor 10 amp fuse is blown

Jan 07, 2011 | 2005 Cadillac SRX

1 Answer

How do I replace the battery in my 2005 Cadillac srx?


how to replace the battery in my 2004 cadillac srx

Oct 24, 2010 | 2005 Cadillac SRX

1 Answer

On a 2005 cadillac srx, v6, how are the cylinder label 1-6?


The firing order is 1-2-3-4-5-6. Cylinders are located on the driver's side front to rear of engine 1-3-5 passenger side front to rear 2-4-6.

Aug 11, 2010 | 2005 Cadillac SRX

1 Answer

How do i chnage the running light on a 2005 cadillac srx


Depending on which side you are working. Here are the steps that I found that works for me.
1. Remove the wheel
2. Remove all inner plastic guards, to include the bottom one
3. Locate the light assembly
4. Remove all Torque Head screws
5. Remove cover
6. Locate light plug and twisted it to remove
7. Replace light
8. Re-install all removed parts
9. Finished
The whole task could take up to 45 minutes depending on SNAFU's

Apr 22, 2010 | 2005 Cadillac SRX

1 Answer

Top rear vents blow out cold air[ 2005 cadillac srx ]


Hello according the the manual, the back vent are to blew cold air only..the fronts vents are suppose to the entire car...

Feb 01, 2009 | 2005 Cadillac SRX

2 Answers

Replacing front turn signal bulb on 2006 Cadillac SRX


You must take the front wheel off, then remove the inner front fender panels (2), they are fastened with plastic pushbuttons. this exposses the light housings for the turn and fog lambs. This takes about an hour, but saves you alot of money.

Nov 12, 2008 | 2006 Cadillac SRX

Not finding what you are looking for?
2005 Cadillac SRX Logo

Related Topics:

85 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

Marvin
Marvin

Level 3 Expert

81285 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...