SOURCE: water pump location on the 2.5L V6 engine 1999 cougar
It is located on top of the engine under the throttle body, it sucks, plan on a whole day if you are a good machanic.
SOURCE: 1999 Mercury Cougar Serpentine belt
try autozone.com to see if they have your car listed for diagrams pictures and step by step instructions if your car is not listed then try your local library they have all the car manuals and even copy them for you
SOURCE: How do I check the clutch fluid to a 1999 Mercury Cougar 4cyl
The brake master cylinder reservoir has a separate chamber and is used to supply the hydraulic clutch system. So make sure master cylinder reservoir is full.
http://i253.photobucket.com/albums/hh43/chuck943/M1601026.jpg
Here is a pic of the system.
1. Brake master cylinder reservoir
2.Clutch master cylinder
3.Clutch slave cylinder with integrated release bearing
SOURCE: o2 sensors on a 99 mercury cougar v6
I just got done replacing the O2 sensors in my 99 Cougar due to throwing a P0135 malfunction code. There's 3. Facing the engine there's one in the front coming off of the front header, which is easy to get to. Another more tricky one if between the engine and the fire wall on the rear header pipe. The third is under the vehicle behind the transmission pan on top of the exhaust. In order to replace the O2 sensor near the fire wall you will need to remove the 4 retaining bolts for the ECM module and move it out of the way. Additionally you will need to remove the 2 retaining nuts for a wiring harness that is seated below the ECM module. Pay close attention to the connectors because the front and under vehicle O2 sensors have round connectors the one near the firewall has a squared connector. I was able to replace all 3 by myself in approximately 35 minutes. If your throwing a O2 heater malfunction code it is most likely going to be the sensor near the firewall. make sure that you know someone with a code reader so the code can be cleared. If you're do for an emmissions inspection be sure to put at least 40 miles on the new O2 sensor with different types of driving (e.g. highway, coasting, decellerated turns and rapid acceleration). Gotta love project cars for your kids!!
SOURCE: Where is the Vehicle speed sensor located on a
2.0L is on the lower rear of transaxle. 2.5L is on the right side of the transaxle.
244 views
Usually answered in minutes!
I have a haynes manual but it doesn't show the fusible links, only mentions them
ur library sec 629 has chilton/mitchell shop manuals used by commercialmechnics
×