Question about 2004 Chevrolet Venture Passanger

2 Answers

When breaking at high speed, the car is vibrating

Posted by on


2 Answers

  • Level 1:

    An expert who has achieved level 1.


    An expert whose answer got voted for 2 times.

  • Contributor
  • 3 Answers

Front rotors are warped. Need to replace them.

Posted on Jul 29, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 2,004 Answers

Take the car for wheel balancing and alignment. Also check the braking system.
Good luck.
Rate this please.

Posted on Jul 12, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

The whole body of the car vibrate, when I drive high speed and only when I touch the break, also I can not stop the car in a place where I need. what is the problem?

You have break issues, possibly a warped rotor, a bad caliper. From your description it sounds like your braking distance is very long compared to normal. A clogged or bad brake line on one side will do this.

Feb 12, 2016 | Cars & Trucks

1 Answer

Vibration in drive train started in higher speeds, not vibrates at all speeds

check drive line "U" joints and cv joints for failure.

Jun 12, 2015 | Cars & Trucks

1 Answer

Vibration when using brakes at high speed

If the ABS is faulty the ABS warning light should be on.
Chances are the vibration is a warped rotor or drum.

Jul 28, 2012 | Chevrolet Cobalt Cars & Trucks

1 Answer

Steering wheel vibrates when hitting the break at high speeds. was told that the steering column knocked when I had the car inspected a few months ago, but they said it was nothing serious. I was just...

Hi, this symptom is usually caused by warped brake rotors. You can have your rotors resurfaced at any brake shop or you can just buy new ones, depending on the cost breakpoint for your vehicle.

May 30, 2011 | Chevrolet Malibu Cars & Trucks

2 Answers

After replacing battery in engine off condition, engine idle speed less than400RPM and high vibration. Engine pick up speed as accelerator pressed

Might need an oil change...use a decent grade of oil too. Try Toyota dealer too. They can help out a little clearer.

Apr 19, 2011 | 2007 Toyota Land Cruiser

1 Answer

When braking at high speed, steering wheel get vibration

sounds like high spots or warping on your break rotors you need to get them checked.

Apr 23, 2009 | 2006 Subaru Legacy

1 Answer

Vibration in steering wheel while breaking?

I would have all 4 tires high speed balanced. Rotors only show out of round problems on brake application.

Apr 03, 2009 | 2003 Chevrolet Impala

1 Answer

Intermttent vibration front end at high speeds

Vibration during acceleration is probably from axle going bad. Intermittent vibration at high speed could be a loose piece of plastic under the car or in the wheel well.

Aug 10, 2008 | 1992 Mazda MX-3

Not finding what you are looking for?
2004 Chevrolet Venture Passanger Logo

Related Topics:

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

81423 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides